How to enable or disable ECU functions in Elm?
How to enable or disable ECU functions in Elm?
Steps: De-solder pin 6 from the OBD port (Make Sure you label this wire if you have not used colour cable) De-solder pin 14 from the OBD port (Make sure you label this wire if you have not used colour cable) Solder pin 6 (which you just de-soldered) to the middle pin on your switch (middle bottom in diagram)
What can I do with the ELM327 modification?
ELM327 Modification First peel off the sticker on the front of the ELM OBD module, to reveal 4 positive head screws Now the ELM is open, you can remove both white plugs pictured below – this will allow us some space to work with. You can also remove the OBD plug by pulling the plug out of the housing, this will allow us to cut the required wires.
Where are the fault codes on Elm config?
This is the main screen of ELMConfig – Along the left hand side is the main module navigation, with the Low CAN & High CAN modules. Below this, you can read the fault codes within each module, and also clear the codes to prevent the warning lights showing.
Where are the positive head screws on an elm?
First peel off the sticker on the front of the ELM OBD module, to reveal 4 positive head screws Now the ELM is open, you can remove both white plugs pictured below – this will allow us some space to work with. You can also remove the OBD plug by pulling the plug out of the housing, this will allow us to cut the required wires.
Where do you go to replace a gem module?
So I guess that a GEM replacement job must go to a Ford dealership. Have to assume they program it correctly in order to have all those features you mention to be operational. news: [email protected]… > [email protected]… >> computer reads my speed correctly. >> Is that true.?
What does the gem do in a Ford?
A General Electric Module (GEM) is a computer component in an Ford automobile that checks, regulates and operates electronic devices throughout the car. Typically in a car the GEM or BCM controls the power windows, power mirrors, air conditioning, immobilizer system, central locking, etc.
Steps: De-solder pin 6 from the OBD port (Make Sure you label this wire if you have not used colour cable) De-solder pin 14 from the OBD port (Make sure you label this wire if you have not used colour cable) Solder pin 6 (which you just de-soldered) to the middle pin on your switch (middle bottom in diagram)
Where can I find a gem wiring diagram?
Gem wiring diagrams are available in .pdf format. Once opened, you may save it to your hard drive. You may also wish to print the PDF on 8.5×11″ paper. 1 Motor Control Systems- GR1 / GR1A – click herefor wiring diagram (added ELITE MOTOR)
