How to change the wheel bearings on a jeep?

THERE IS AN O-RING ON THE OLD HUB THAT YOU WILL NEED TO RE-USE IN THE NEW HUB ON THE SIDE THAT GOES INTO THE AXLE (ON THE OUTSIDE DIAMETER) – clean it and inspect it for nicks and damage. if it’s good, insert it and rub a bit of oil on it . FEEL FREE TO REPLACE IT SINCE YOU ALREADY HAVE IT APART IF YOU THINK IT NEEDS IT.

How to replace rear axle seal on Jeep Grand Cherokee?

This video shows you how to go through the process of replacing a leaking rear axle seal on a WJ (1999-2004) Jeep Grand Cherokee. This procedure would be very similar for many other solid axle Jeeps as well as many other vehicle makes and models. Loading…

How do you change wheel bearings on a Toyota Tundra?

On vehicles where the wheel bearing is pressed into a cavity within the steering knuckle, the steering knuckle must be removed from the vehicle in order to press out the old bearing and press in the new bearing. On some vehicles, the wheel bearing is pressed onto an axle shaft and thus the axle must be extracted from the axle carrier.

How are wheel bearings removed from a vehicle?

On vehicles with unitized wheel bearing/hub assemblies, the brake rotor and caliper are removed. The large axle nut is removed, the axle is pushed back through the center of the unitized hub assembly, and three (or more) bolts holding the hub assembly to the steering knuckle are removed. The hub assembly is then removed from the knuckle.

How to replace a wheel bearing on a Jeep Cherokee?

How to replace a wheel bearing (wheel hub) on a Jeep Cherokee. This Cherokee has a sealed hub unit. Older models have a separate bearing that require additional tools to press the old bearing out and the new one in. With a hub replacement, the repair should only take a half an hour barring any problems with seized bolts.

How long does it take to replace wheel hub on Jeep Cherokee?

Please try again later. How to replace a wheel bearing (wheel hub) on a Jeep Cherokee. This Cherokee has a sealed hub unit. Older models have a separate bearing that require additional tools to press the old bearing out and the new one in. With a hub replacement, the repair should only take a half an hour barring any problems with seized bolts.

Do you need to replace rear wheel bearings?

FEEL FREE TO REPLACE IT SINCE YOU ALREADY HAVE IT APART IF YOU THINK IT NEEDS IT. Insert the new hub, it only goes in ONE WAY so as long as the bolts line up with the holes, you’re good to go.

How to change the wheel bearings on a jeep?