How to change differential oil in a backhoe loader?
How to change differential oil in a backhoe loader?
Page 17 202 Maintenance Section Differential Oil (Front) – Change i00601036 Differential Oil (Front) – Change SMCS Code: 3258 g00290684 Illustration 297 6. Loosen the hose clamp and remove the hose from the thermostat housing assembly. g00290687 7. Remove the bolts from the thermostat housing Illustration 2
How to change coolant on a backhoe loader?
Page 12 197 Maintenance Section Cooling System Coolant (DEAC) – Change NOTICE Do not change the coolant until you read and under- stand the material in the Cooling System Specifica- tions section. 1. Empty the bucket. Remove the pin that secures the loader lift arm brace to the left loader lift arm.
How do you replace the breather on a backhoe loader?
1. Clean the area around the breathers. Remove the breather from the front axle. 2. Wash the breather in clean nonflammable solvent. Wipe the breather dry and check the breather for damage. 3. Install the clean breather back into the axle. Replace the breather if the breather is damaged.
How big is the locknut on a backhoe loader?
Inspect the condition of the air conditioner belt and the adjustment of the air conditioner belt. (0.38 inch) under 110 N (25 lb) of for ce. 8. Loosen the adjusting locknut (1).
1. Clean the area around the breathers. Remove the breather from the front axle. 2. Wash the breather in clean nonflammable solvent. Wipe the breather dry and check the breather for damage. 3. Install the clean breather back into the axle. Replace the breather if the breather is damaged.
How do you turn off a backhoe loader?
1. Turn the engine start switch to the OFF position. Turn all switches to the OFF position. 2. Disconnect the negative battery cable from the frame. Note:Do not allow the disconnected battery cable to contact the frame of the machine. 3. Disconnect the negative battery cable at the battery. 4.
Who is responsible for maintenance of a backhoe loader?
The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants,fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.
How do you Grease a backhoe loader stick?
Apply lubricant to the grease fitting (2) for the head end of the boom cylinder and the head end of the stick cylinder. Apply lubricant to the grease fitting (3) for the rod end of the boom cylinder. Apply lubricant to the grease fitting (4) for the boom pivot. There is one grease fitting on each side of the machine.
