How to change coolant on a Ford Mondeo?

Please try again later. Easy DIY how to: flushing and refilling coolant (anti-freeze) on a Ford Duratec HE engine. The car featured is a Ford Mondeo Mk3 (2000–2007) but the procedure is the same for any car using the Duratec HE, e.g. the Focus Mk2. * Floor jack & axle stands, or alternative way to lift front of car. Loading…

Where is the oil cooler located on a Mondeo?

The hose that exits from the oil cooler enters the radiator on the right hand side about 1/3 of the way up and should remain cold until the engine is warm, mine was warm all the time so was taking heat from the engine to the radiator even though the main thermostat was closed.

Why is my Ford Mondeo Mk3 running low?

From what I have read, a fault with the ‘oil cooler thermostat’ can also effect the temperature of the engine. The heater does get warm, but the engine temperature is low, it never reaches normal operating temperature. Ok, I fitted a new coolant thermostat at the weekend.

What kind of car is the Ford Mondeo?

The car featured is a Ford Mondeo Mk3 (2000–2007) but the procedure is the same for any car using the Duratec HE, e.g. the Focus Mk2. * Floor jack & axle stands, or alternative way to lift front of car. Loading…

Is the radiator drain plug on a Ford Mondeo?

Following on from here, kind of: http://www.fordownersclub.com/forums/topic/47311-argh-this-flippin-car/ I didn’t change the radiator as the repair, as ugly as it was, seemed to be structurally fine. Today my wife was just off to her mate’s house, as she reversed back I noticed a small puddle under the front of the car.

When did the Ford Focus radiator come out?

The condenser stays in place with you remove the radiator. The model shown is a first generation 1998 to 2004, so covers years 1998, 1999, 2000, 2001, 2002, 2003, and 2004. Mark 1. Loading…

What kind of engine does second generation Mondeo have?

For the second generation Mondeo, the Zetec engine was replaced with 1.8 and 2.0 litre Mazda L engines, branded Duratec by Ford.

When did Ford start making the Ford Mondeo?

The Ford Mondeo is a large family car manufactured by Ford since 1993.

What was the problem with the Ford Mondeo?

There was a design flaw with the new 1.8 and 2.0 L petrol units with the butterfly valves in the inlet manifold, which could cause severe engine damage when they failed.

What causes a Mondeo heater to go cold?

The outlets from the cylinder head to the heating system, and to the thermostat and radiator, are quite high up on the cylinder head. If the coolant level falls below this height, and air gets in (or steam if the engine is warm), then circulation will stop, and the heater will go cold, while the engine will overheat.

What’s the solution to the Ford Mondeo common problems?

Solution: A common problem is over heating and subsequent high resistance of the speaker multiplug terminals. The solution is to fit a revised speaker loom multiplug that have improved heat resistance. A revised speaker loom multiplug has been fitted since 06/1997.

How to stop coolant bleeding in Ford Focus Club?

If you are worried about air in the system just fill the system to minimum level and run with the reservoir cap off and cabin heater to full / fan on setting 1 so all the water feeds are circulating.

What to do if your Ford Mondeo has a problem?

This can also create small metal particles to contaminate the diesel and damage many components including the injectors. A sample of diesel should be inspected. A new diesel pump with revised rollers and shoes should be fitted along with new injectors and other parts if required.

What does selective unlocking do on Ford Mondeo Mk4?

Activating in your Ford Mondeo MK4 selective unlocking will increase your, passengers and baggage safety. This feature will cause that when you open your car, driver door will unlock first. Second press of the UNLOCK button on the key fob will unlock rest of the doors and the trunk. Continue reading …

How to defrost the windscreen on a Ford Mondeo?

Open the centre and side air vents. Direct the air vents toward your face. Recommended settings for heating Open the centre and side air vents. 7 Direct the side air vents toward the side windows. Defrosting and demisting the windscreen Note:Turn the air conditioning on to assist windscreen and side window demisting.