How much is reasonable for a ball joint replacement at Chrysler dealership?

Vocational, Technical or Tra… Vocational, Technical or Tra… How much is reasonable for a ball joint replacement at a Chrysler dealership? I own a 2008 dodge caliber with 57,000 miles on it. Was quoted … read more Vocational, Technical or Tra… I need to replace upper & lower ball joints on a 2004 Dodge Ram cummins diesel.

How to replace the upper control arm on a Chevy Silverado?

Place the floor jack underneath the wheel knuckle and jack it up three inches (7.5 cm) or so. Remove the 18mm nut securing the upper control arm ball joint to the knuckle. With the nut removed, pull the control arm free from the knuckle. At this point there is no tension on the camber bolts of the two attachment brackets. Figure 9.

What are the ball joints on a Dodge Dakota?

My 2001 Dodge Dakota 4WD needs upper and lower ball joints (according to the tire and alignment shop.) Parts estimate seems … read more Vocational, Technical or Tra…

How many hours labor to replace all four ball joints on?

I own a 2008 dodge caliber with 57,000 miles on it. Was quoted … read more Vocational, Technical or Tra… I need to replace upper & lower ball joints on a 2004 Dodge Ram cummins diesel. Could you send me the step by step instructions and diagrams. … read more Master Level Chrysler Tech…

What do I need to replace upper control arm?

The upper control arm bushings can be replaced using a bushing removal tool or bushing press. However, if the ball joint has failed, the entire upper control arm needs to be replaced because this ball joint is not serviceable. Bushing removal kits can be rented from an auto supply store, often at no cost to customers.

My 2001 Dodge Dakota 4WD needs upper and lower ball joints (according to the tire and alignment shop.) Parts estimate seems … read more Vocational, Technical or Tra…

How to replace the ball joints to a 99 Ford Explorer?

3) Remove lower ball-joint castle nut and upper ball joint retaining bolt 5) Retract the axle out of the steering knuckle and suspend it using a bungee cord out of the way. 8) Pound the lower ball joint back out with a hammer or use a press tool. 9) Remove upper control arm and replace (It houses the upper joint).

What’s the best way to replace a ball joint?

Screw in the new grease fitting and pump grease into the assembly. If you removed the brake or wheel, reattach them and lower the vehicle back down to test out the action. Bleed the brakes, if necessary. It’s a good opportunity to do any other repairs you might need to do with the brakes, since you’ve got them off.

How much is reasonable for a ball joint replacement at Chrysler dealership?