How much does it cost to replace a BCM in a GM Truck?

How much does it cost to replace a BCM in a GM Truck?

I have checked the wiring for opens, shorts to ground or power, or high resistance and the wiring seems to be fine. So the next step in the troubleshooting procedure is to replace the BCM. GM dealer wants $257 for a new BCM and minimum $90 charge for programming it.

Can a BCM be replaced in my driveway?

AllOffTopic.com FTW! Your remote starter probably messed up something in the antitheft system, not the BCM. You can’t do it in your driveway without a tech 2 and a connection to GM tech site. you have to reprogram the BCM that way.

Is the BCM the same as the PCM?

Yes the BCM is different than the PCM. This unit controls body functions not drivetrain functions. i have a used BCM from an 02 silverado ext cab 5.3l for sale if you can get it reprogrammed. have the remotes too if you need them with it. pm me if youre interested, i probably wont see this thread again. gl

Where is the BCM located on a car?

Your vehicle’s BCM is below the right side of dash, near blower motor. helpful? helpful? Ensure that the ignition switch is in the off position. Remove the right sound insulator.

How to replace BCM in GM classic truck?

INSTALLING THE REPLACEMENT BCM IN THE 2003-2006-2007 CLASSIC TRUCK/SUV IS VERY STRAIGHTFORWARD AND IS OUTLINED BELOW. 1. LOG INTO THE GM SPS TERMINAL AND PERFORM THE 10 MINUTE VTD RELEARN.

Where can I find BCM 03-07 classic gmflash?

WE program 2003-2007 Classic GM truck/SUV Body CONTROL MODULES, OFF THE VEHICLE, FOR PLUG AND PLAY OPERATION. Installation instructions can be found near the bottom of this page. FOR PROGRAMMING SERVICE: Please call US AT 314-43FLASH TO ORDER PROGRAMMING FOR THIS SPECIFIC MODULE.

How to program security code in GM BCM?

You could do this, you will have to program the security code first. Then drive it in to have the RPO’s programmed in the BCM. 1 Turn ON the ignition, with the engine OFF. 2 Attempt to start the engine, then release the key to ON; the vehicle will not start. 3 Observe the SECURITY telltale; after approximately 10 minutes the telltale will turn OFF.

Can a truck start without a BCM module?

Again on an 07 this would be true but not on an 03. The truck will not start without the bcm because of the security but it does not send out the on signal for the other modules like a new one would. Believe me, I’ve been all over this truck checking things and testing. At this point my next step is to replace the bcm.