How long does it take to change a wheel bearing on a Ford Focus?
How long does it take to change a wheel bearing on a Ford Focus?
Rear wheel drive, tapered roller bearing: about 15-45 minutes; wear gloves or spend another 10 minutes washing grease off your hands. Front wheel drive with pressed on bearing: 30–120 minutes depending on whether it can be pulled off and pressed in with a specialty tool.
How many wheel bearings does a Ford Focus have?
Your car has four bearings; one for each wheel.
How much does it cost to replace a front wheel bearing?
For most vehicles, wheel bearing replacement cost is usually between $125 and $750, and rear-wheel bearing replacement cost is usually the same as a front wheel bearing replacement.
How do you replace wheel bearing on Ford Focus?
Get a bushing from the kit that has a larger diameter than the wheel hub ring. Attach the components together using the sliding screw, washer and slide screw long nut. Torque and press the shaft of the wheel hub into the inner race of the wheel bearing until the slide screw nut stops moving. disassemble the components.
How much does it cost to replace a wheel hub?
Replacement bearings can be purchased as a kit, and the extra cost of the hub is nominal. Note: If you are not using a FWD bearing installation kit or a standing hydraulic press, don’t try to “hammer” a bearing into the steering knuckle with makeshift bushings. This will most likely ruin the bearing in a matter of a few weeks.
How to replace front wheel hub and wheel bearing?
Begin pressing the the bearing into the steering knuckle with a powered impact driver tool. You will know the bearing is fully seated when the impact driver suddenly struggles to keep turning. That is, the rotational force will suddenly stop. 3. Disassemble the components. 4. Install the new snap ring. 6. Pressing in the Wheel Hub
How much does it cost to replace front wheel bearings?
Example Table of Front Wheel Bearing Replacement Costs Model Labor Parts Total Ford F-Series $162-$207 $240-$538 $402-$745 Ford Focus $360-$459 $264-$420 $624-$879 Ford Fusion $252-$321 $184-$256 $436-$577 Toyota Camry $252-$321 $150-$230 $402-$551
How to replace front hub and wheel bearing in Ford Focus?
This DIY provides the basic procedure, in a video and in words, for replacing the front hub and wheel bearing in a 2000-2011 Ford Focus (and video only of a 2008 Ford Fusion) without removing the steering knuckle and without using a standing hydraulic press machine.
Replacement bearings can be purchased as a kit, and the extra cost of the hub is nominal. Note: If you are not using a FWD bearing installation kit or a standing hydraulic press, don’t try to “hammer” a bearing into the steering knuckle with makeshift bushings. This will most likely ruin the bearing in a matter of a few weeks.
How do you remove a wheel bearing from a Ford?
Remove the suspension strut bolt from the steering knuckle. Apply hammer blows to the top of the steering knuckle to separate the knuckle away from the suspension strut. Pull the CV axle shaft away from the steering knuckle hole. Remove the snap ring out of the snap ring groove of the steering knuckle. 4. Removing the Bearing
