How is the solenoid closed on a bobcat?

16-06 The holding solenoid of blocking of thrust is closed on weight 16-07 Breaking the chain retaining solenoid blocking traction 17-05 Solenoid hydraulic shut-off valve shorted to battery 17-06 Solenoid hydraulic shut-off valve shorted to ground

What is the fault code for the bobcat controller?

33-23 Main controller (Bobcat controller) not programmed 34-04 Pushbutton panel not communicating with Bobcat controller 35-02 Two-speed fan switch, erroneous on 35-03 Two-speed fan switch, erroneous shutdown 36-48 Multiple ACD controllers connected 37-02 Two-speed additional speed switch, erroneous activation

What does the error code m2303 mean on a bobcat?

The error code of M2303 indicates that there is something wrong with the rear base solenoid. Usually it is the problem of unexpected shutdown on this particular part. There is front and rear solenoid on the machine.

What does 03-09 mean on a bobcat battery?

The error code of 03-09 is one of the most common codes that you will encounter. It indicates “Low battery voltage”. When your Bobcat equipment is using a rechargeable battery, make sure there is still enough power to run the machine. If the power is low, recharge the battery as soon as possible.

What is code 32-31 on bobcat bucket?

Code 32-31 is a tilt actuator fault. Is this only occurring when using the joystick controls for tilt? YES OR THE FOOT PEDAL FOR TILT. IF SHUT OFF AND RESTARTED, CODE IS GONE TILL THE HANDLE OR FOOT PEDAL IT OPERATED, TILT NEVER OPERATES. The tilt actuator is an electrical motor that moves the spool valve. Bobcat had trouble with these.

Why does my T300 Bobcat bucket not tilt?

If you also have foot pedals like most, the harness goes down into the pedal area, and rubs hidden behing the side panels can also give codes like “Tilt handle/pedal short to ground“, but that’s aside from actuator codes. Since version 50-something software, swapping the actuator plugs as a test does not work.

What is the problem with the bobcat S300?

We are having a problem with the bobcat s300 that we have. You start it up and seconds after that the tilt/lift light comes one. ACS error. The reference guide just says acs error tilt/lift. We noticed it was a bit damp under the cab so we took the cab back and left it inside all weekend with a fan on it in a heated shop.

What is the PWM controller code for a bobcat?

12-23 PWM controller front ext. non-neutral hydraulics 13-05 Fuel holding solenoid retainer shorted to battery 13-06 Retention fuel cut-off solenoid shorted to ground 14-02 Fuel Cut-Off Solenoid Solenoid Incorrectly Switched On

What is the error code on a bobcat?

If and positive leads first. DISPLAY (Item 2) [Figure 60-80-1]. If more than one HOUR METER/CODE DISPLAY. 38-48 Front left steering solenoid error ON 38-99 Controller in wheel position calibration mode.

Where is the loader button on a Bobcat skid steer?

LOADER Button is pressed. LOADER Button is pressed. Seat Bar is down. Seat Bar is up. Lift and tilt functions will not operate. Seat Bar sensor circuit shorted to battery voltage*. Seat Bar is down. Seat Bar is up.

Who are the owners of Bobcat construction equipment?

Bobcat is a Doosan company. Doosan is a global leader in construction equipment, power and water solutions, engines, and engineering, proudly serving customers and communities for more than a century.

How is the solenoid closed on a bobcat?