How do you turn up the pump on a Bosch P7100?

How do you turn up the pump on a Bosch P7100?

The steps for turning up a P7100 pump are:

1. Remove your AFC Housing.
2. Mod Your Fuel Plate either slide it forward or purchase a cut one.
3. Adjust the governor lever to contact the fuel plate.
4. Crank the star Wheel Towards the motor.
5. Slide The AFC housing all the way forward.

Can I put AP pump on a 24 valve Cummins?

While the 24-valve 5.9L Cummins found in ‘98.5-02 Dodge Rams can be a great workhorse engine, it leaves much to be desired in the way of reliability and horsepower potential. P-pumping a 24-valve 5.9L Cummins requires complete access to the front cover and gear housing so that they can be removed.

What’s AP pump Cummins?

The P-Pump, as Tyler puts it, is “basically a little engine in itself.” Driven by the engine’s cam gear, the P-Pump is an injection pump that gets fed fuel from the lift pump (which takes fuel from the tank). The injection pump’s six plungers—which ride on a camshaft in the pump housing—move up and down in barrels.

What kind of horsepower does a Cummins P7100 have?

It represents easy horsepower for those handy with a wrench, huge horsepower for anyone willing to spend some money and — like the Cummins engine it was bolted to — million-mile durability. In this article we’ll explore all the components within the P7100 that can be modified to improve its performance.

Where is the air fuel control assembly on a Cummins P7100?

At the back of the P7100, you’ll find the air fuel control (AFC) assembly. In addition to dictating when the governor arm hits the AFC arm, the AFC is in charge of controlling the pump’s fuel rate at low boost.

Can a Mack rack plug be installed on a P7100?

It’s important to note that the best way to install the Mack rack plug is with the pump off the engine. If the pump stays in place, some grinding of the timing cover will be in order. In addition, the Mack rack plug isn’t typically recommended for 215 hp pumps (the P7100 used on ’96-’98 trucks with five-speed manual transmissions).

What should the timing be on a P pump Cummins?

However, a pump that’s set at 18 to 20 degrees of timing advancement will see impressive gains. The 18 to 20-degree mark is the unofficial sweet spot for timing on a P-pumped Cummins in that it allows for good all-around power, drivability and cold-start performance.

What kind of rack Cap Fits Bosch P7100 pump?

ATTITUDE PERFORMANCE PRODUCTS 1007 P7100 Rack Cap – Fits Bosch P7100 PUMP. Drilled 4mm deeper than stock rack cap. Allows full rack travel & provides 20+ more HP. Billet Aluminum ATTITUDE PERFORMANCE PRODUCTS 1020 The ADJUSTER by Attitude.

Which is the fuel controller for the P7100 injection pump?

ATTITUDE PERFORMANCE PRODUCTS 1020 The ADJUSTER by Attitude. In-cab fuel controller for the P7100 injection pump. Full control on the fly!

How can I increase HP on my P7100 pump?

Sliding the stock plate will increase HP quite a bit. This is a cut away view of the governor of a P7100 pump. Notice how the lever hit the cam plate flush at the very bottom edge. To check your adjustment the throttle lever needs to be moved until the lever just touches the cam plate.

Where is the locknut on a P7100 pump?

The adjustment in the lower left hand corner is the one to make. Loosen the locknut ( 10mm socket required ). Making very small adjustments to the screw, adjust the lever the proper height. Now tighten the locknut. One thing to realize about the plate is that it is properly called a full load throttle stop.