How do you turn off the airbag light on a Ford Escape?
How do you turn off the airbag light on a Ford Escape?
To reset the airbag light in a Ford Escape You can follow these directions listed here – Step 1 insert the key into the ignition and turn the switch to “on”. Step 2 Pay attention tot he light as it will illuminate for seven seconds and then shut off. After the shut off turn the ignition off and wait for 3 seconds.
How do you remove airbag from steering wheel?
Carefully pull the airbag module rearward away from the steering wheel just far enough to disconnect the wires from the back of the module (see Illustration 1 above). Do not pull on the clockspring wires or pry on the connector insulator to disengage the connector from the receptacle on the clockspring.
How to remove plastic filler from steering wheel?
Once your Steering Wheel has been removed, using a Torx 15 screw driver remove the two screws holding the plastic filler on the back of the wheel. 2.
Where can I change the steering wheel in my Ford?
NOTICE – GRANTrecommends that installation be performed by a qualified service provider such as your local Ford dealer, a certified mechanic, collision repair shop or a local airbag service center. Many of these service centers will come to your home or place of business to change out the air bag and wheel for a nominal fee.
Do you need to disengage the air bags in a Ford Escape?
Any time you plan to work on either the front seats or any components within a Ford Escape’s dashboard, steering column, or center console, you will need to disengage the air bag system.
For some applications the bolts will be retained in the wheel and will not come out which is normal. Once one side has been removed or released turn the steering wheel in the opposite direction 180°. Then locate and loosen or remove the opposing mounting bolt or retainer clip. Gently grasp the assembly while pulling it away from the steering wheel.
Where is the restraints control box on a Ford Escape?
You find this box on the right side of the center console. Remove the Restraints Control Module fuse from the Smart Junction Box. For the exact location of the fuse, consult the owner’s manual or a Haynes Repair Manual for your particular model year. Place your key into the ignition and turn to the “On” position. Watch the air bag warning light.
How do you reinstall an airbag in a car?
Once repairs are completed such as removing the steering wheel to replace the turn signal switch, cruise control or ignition switch simply reinstall the airbag by reversing these steps. Most electrical connectors produce an audible click to confirm their proper installation.
