How do you take a torsion bar out of a car?
How do you take a torsion bar out of a car?
Slowly loosen the puller until all pressure is relieved from the adjusting arm. Pull the torsion bar out of the cross-member. When the bar is clear of the cross-member, pivot it down and pull it out of the lower control arm to remove it. Catch the adjusting arm, it will fall out.
How do you change the bolts on a torsion bar?
Use a ratchet and socket to remove the adjusting bolts. Note that the bolt runs through a special nut that fits in the cross-member. Attach a two-jaw puller to the sides of the cross-member just in front of the adjuster nut. Run the threaded rod up against the adjusting arm that is sitting on top of the adjusting nut.
Which is the front and rear torsion bar?
You might see both front and rear torsion bars beneath your vehicle. The front torsion bar is closest to the engine, and it’s what you’ll be adjusting. The front torsion bar has a small key in the center. This key helps the bar stay in place.
How do you replace ball joint on McPherson strut?
Leave the castellated nut in place, just a few turns in to keep it in a safe place. If you’re working on a McPherson strut suspension remove the “pinch bolt” that clamps the ball joint stud. Pop loose the ball joint.
How do you remove the torsion bar from a car?
Take the torsion bar adjusting arms off of the torsion bars with your hands. Unbolt the torsion bar crossmember with the 1/2-inch ratchet and socket. Pull the crossmember off of the frame. Slide the torsion bars towards the rear of the vehicle and out of the lower control arm. Take them away from the vehicle.
How do you remove the torsion bar on a Dakota?
Unbolt the torsion bar crossmember with the 1/2-inch ratchet and socket. Pull the crossmember off of the frame. Slide the torsion bars towards the rear of the vehicle and out of the lower control arm. Take them away from the vehicle. Raise up the Dakota using the jack and set the frame on four jack stands.
Where are the torsion bars located on a GM Truck?
Locate the torsion bars, which run down the length of the vehicle and connect the lower control arms to the torsion bar crossmember. Install GM Tool J-36202 onto the torsion bar keys, which are located in the torsion bar crossmember that runs the width of the vehicle and is just below the cab of the vehicle.
Where can I get a torsion bar unloading tool?
Torsion Bar Unloading Tool, Chevy, GMC, Oldsmobile, Each Part Number: OES-27235 More Detail… Torsion Bar Key Unloading Tool, Chevy, GMC, Each Part Number: RLS-66-7822B More Detail… This part is normally shipped directly from the manufacturer / Supplier. Order this item and get free delivery and handling on your entire order!
