How do you seal the front axle tube?

1. Jack the jeep up and put the axle on jack stands. 2. Remove the tires. 3. Pull the tie rod (gives you way more room). 4. Drain the Diff and pull the diff cover. 5. Remove the front axle shafts. 6. Remove the bearing cap bolts. 7. Remove the bearing caps. 8. Take note of the shims on each side of the carrier. I only had 1 shim on each side.

When do you need an axle seal replacement?

Let’s start with the first question. The axle seal replacement is not a part of regular maintenance, the seal only needs to be changed if it leaks. How do you know if an axle seal is leaking? Gear oil or transmission fluid drops on your driveway are some of the early signs.

What kind of axle seal does a 1998 Dodge Ram use?

Please try again later. The right front axle seal on a 1998 Dodge Ram 4X4 can be difficult, because of limited access to the seal insertion site. That vehicle uses the popular Dana 44, 216FBI axle, used in many light trucks of that vintage.

Do you need to clear the axle housing?

The axle shafts need to clear the axle housing to be fully removed. If you are going to perform a standard rebuild, which means replacing bearings, seals, and clutch pack, it is imperative to take good notes of the shims’ locations so you can return the axle back into service with minimal adjustments required.

How much does it cost to replace rear axle seal?

If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely. These axles are available at the dealer for about $200.00 bucks. Now we are ready to remove the seal.

When to replace rear axle bearings and seals?

After the axle has been removed inspect the bearing and seal surface to check for wear and scoring and replace if damaged. If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely.

How do you seal the front axle tube?