How do you reset the tire pressure sensor on a 2014 Equinox?

First park the vehicle and make sure the tire pressure is at the correct level of 35 psi in the front and rear tires. Then drive for 2 minutes of cumulative driving at 20 mph and then stop, turn off and turn on the vehicle. If that did not work, You will need a reset tool to complete it.

How does TPMS work on a Chevrolet Equinox?

The Chevrolet Equinox is manufactured with a direct TPMS system. Direct TPMS has TPMS sensors installed in the wheel; if one or more tires indicate low tire pressure, the TPMS sensors will transfer the information to the vehicle’s ECU. An indicator light (low-line TPMS system) or each tire pressure will show on the dash (high-line TPMS system).

How to relearn the GM TPMS setup procedure?

Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position. Proceed to the passenger side front tire, and repeat the procedure in Step 8.

When to reset tire pressure sensor on Equinox?

Unlike the previous model year, you’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System in this 2011 2012 2013 2014 2015 2016 2017 Equinox model year. Follow these steps to do it: Start from the driver side front tire, place the TPMS Relearn Tool against the tire sidewall, near the valve stem.

How to reset a Cadillac TPMS in relearn mode?

1. Inflate all tires to the pressure listed on the placard. 2. Turn ignition to the ON/RUN position with the engine OFF (not the ACC position). 3. Turn the headlight switch from OFF to parking lamps 4 times within five seconds. The horn sounds twice to signal the receiver is in relearn mode.