How do you reset the service light on a 2011 Dodge Ram 2500?
How do you reset the service light on a 2011 Dodge Ram 2500?
Press and release the brake pedal two times. Fully depress the accelerator pedal slowly two times within 10 seconds. Turn the ignition switch to the OFF/LOCK position. The message should now be erased.
How do I delete messages on Uconnect?
To do so, press the Uconnect phone button, which looks like a telephone and is located on either the center console or the steering wheel, and say “Setup, SMS incoming message announcement.” Then follow the prompts to turn off the announcements.
How to perform service message on Dodge Ram?
1. Turn the ignition switch to the ON position (Do not start engine ). 2. Press and release the brake pedal two times. 3. Fully depress the accelerator pedal slowly two times within 10 seconds. 4. Turn the ignition switch to the OFF/LOCK position.
What is the trouble code on a Dodge Ram?
Chrysler has issued a service bulletin #21-005-12 to address a service 4WD light on Dodge Ram on the vehicles listed below. In addition to the service 4WD light on Dodge Ram, owners may also have a C2201 -FDCM/DTCM Internal diagnostic trouble code.
How do I reset the perform service message?
Unless reset the “Perform Service” message will display on the EVIC each time you turn the ignition switch to the ON/RUN position to indicate a emission maintenance is required. To reset the “Perform Service” indicator system (after performing the scheduled maintenance) refer to the following procedure: 1.
When does service 4WD light come on on Dodge Ram?
The bulletin applies ONLY to vehicles with an electronic transfer case (sales code DH8, DH9 or DK3) built before January 6, 2012 (MDH 0106XX). When the Service 4WD light comes on, it also shuts down the 4WD capability for the remainder of the drive cycle. This is a software issue and can only be corrected by flashing the computer’s memory.
1. Turn the ignition switch to the ON position (Do not start engine ). 2. Press and release the brake pedal two times. 3. Fully depress the accelerator pedal slowly two times within 10 seconds. 4. Turn the ignition switch to the OFF/LOCK position.
How to reset perform service indicator on Dodge 6.7L?
This bulletin is to aid you on resetting the Perform Service indicator you will find on a Dodge 6.7L with the EVIC displaying this message. PERFORM SERVICE INDICATOR- RESET the “Perform Service” message will display on the EVIC each time you turn the ignition switch to the ON/RUN position to indicate emission maintenance is required.
Unless reset the “Perform Service” message will display on the EVIC each time you turn the ignition switch to the ON/RUN position to indicate a emission maintenance is required. To reset the “Perform Service” indicator system (after performing the scheduled maintenance) refer to the following procedure: 1.
