How do you reset the Pats on a Ford Ranger?

Resetting Your Anti-Theft System

Put the key in the ignition.
Turn it to the on position, but don’t start the engine.
Turn it back off again.
Repeat this process eight times, leaving your key on with the final turn.

How do you reset the security system on a 99 Ford Ranger?

1 Answer

You have a little red light on your dashboard-press it to disarm the alarm.
Try turning the key and moving the shift from park to drive and back, then try starting it again.
Disconnect the battery and let it breathe for 20 minutes and more, and reconnect it, that may do the trick.

Why does my Ford Ranger engine shut off without warning?

Engine stalls and won’t re-start due to improper activation of the passive anti-theft system (pats) which is faulty. Engine shuts off, no power assist, lights remain functional, anit-theft dashboard light starts to blink.

What was the problem with my 2005 Ford Ranger?

I am the owner of a 2005 Ford Ranger there was a problem with the transmission. It was taken to the dealer after approximately 5 days we were able to pick the Ford up and the transmission was replaced. Shortly after this the vehicle started to shut down while driving for no apparent reason .

What are the trouble codes for Ford Pats?

Most of the PATS trouble codes are body “B” or data “U” type codes. You must have a code reader that can read these codes. Repairing a PATS system is NOT hard. B1213 Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103 Transceiver internal antenna damaged. Replace transceiver.

How long does it take to re-start a Ford Ranger?

Vehicle will re-start only after removing and re-installing the #19 fuse to re-set the system. It may require several re-sets of thirty or more seconds each, after which the vehicle may run normally for a short distance or up to several months of normal driving.

Is there a no crank problem without Pats?

There is a no-crank problem on vehicles without PATS Starter disable. Check chart, on reverse side, for presence of Starter Interrupt. PATS Theft Indicator flashes every 2 seconds at Ignition OFF. This is normal operation for PATS to act as a visual theft deterrent. See chart on reverse side for applicable system.

How to change the Pats on a Ford?

Simply put the original key in the ignition, turn to ON or RUN and wait for 20 seconds. Then turn the key off and start vehicle. Replacing PCM only — B, C, F or G type PATS If only the PCM is being replaced on a PATS control function type B, C, F or G vehicle, the Parameter Reset function must be performed.

Can a Pats starter disable an engine on the road?

Engine stalls on road: Once the engine runs for one second, PATS CANNOT disable the engine. Running stalls are not PATS related issues. Remote Entry/Keyless Entry problems: PATS is completely separate from the Remote Entry/Keyless Entry systems. There is a no-crank problem on vehicles without PATS Starter disable.

How do you reset the Pats on a Ford Ranger?