How do you reset the electronic throttle control on a Dodge Caliber?
How do you reset the electronic throttle control on a Dodge Caliber?
To reset the system all You need to do is turn on the vehicle without starting the engine. After that You can just press down on the throttle pedal for ten seconds and wait until the engine light starts to blink. When that happens it is resetting the throttle body and the ECU’s memory.
How do you reset service electronic throttle control manually?
Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.
How does electronic throttle control work on Dodge Caliber?
It was so easy and did not have to go back to the dealer. With the key in the on position, but car is not running just all the lights on on the panel, gently push the accelerator pedal to the floor, should take about 20-30 seconds, hold it there for 30 seconds then gently release it all the way out taking another 30 seconds.
Why is my throttle control not working on my Dodge?
The problem could be caused by several other systems, like your Traction/ABS Control, Transmission Control, Engine Control, a Data Bus Problem, a wiring problem etc. There is actually a TSB or technical Service Bulletin for this very problem written by Dodge.
How to fix the electronic throttle on a car?
Then, wait for a minimum of 3 seconds. Now, press the accelerator pedal and do press and release five times amidst 5 seconds. Press the pedal again, and this time hold on pressing for around 20 seconds. At least until the engine light stops the blinking and then stays on.
How is the throttle body of a car controlled?
The electronic throttle body is controlled by the computer engine of the vehicle in modern cars. So, if the throttle body fails then, the computer engine controls it and interrupts from moving the valve and, consequently, helps to save the whole engine from any extensive damage.
What causes the throttle control light to go off on a Dodge Caliber?
See all problems of the 2012 Dodge Caliber . The car will suddenly lose all acceleration and power with no warning. Eventually the throttle control light will illuminate but will eventually go off. The gas pump as been replaced, the throttle control has been replaced, and this is still happening.
Where is the electronic throttle control on a caliber?
Unfortunately, you can’t trust the feature to work on the Caliber line for some reason. The electronic throttle body (ETC stands for electronic throttle control) is located down low in the front of the car… just follow the fresh air duct.
The problem could be caused by several other systems, like your Traction/ABS Control, Transmission Control, Engine Control, a Data Bus Problem, a wiring problem etc. There is actually a TSB or technical Service Bulletin for this very problem written by Dodge.
When does the throttle control light come on?
Driving under normal conditions on a city street while the car was in motion the electronic throttle control light came on the instrument panel and the car began to shudder and drag. I could not accelerate more than 25 mph and the rpms were very high at that low speed.
