How do you reset a fuel line?
How do you reset a fuel line?
Turn the ignition switch OFF. Ensure that there is no fuel leaking in the engine compartment, along any of the lines or at the tank. There should be no odor of fuel as well. If no leakage and/or odor is apparent, reset the switch by pushing the reset button on the top of the switch.
Where is the inertia switch located Ford Ranger?
You can find the inertia switch, which is also known as the fuel pressure inertia switch (FPIS), on Your Ford Ranger’s passenger foot area, under the dash, near the front edge of the carpet.
Where is the fuel pump reset button on a Ford Ranger?
Enter your vehicle from the passenger side and locate the fuel pump shutoff switch near the underside of the glove compartment, on the lower right side. The fuel pump cutoff switch has a small round button. Push the small round button to reset the fuel pump cutoff switch. Start the vehicle and allow the vehicle to run for a few seconds.
How do you reset the oil life on a Ford Ranger?
Press the right arrow button, then from this menu scroll to the VEHICLE. Press the right arrow button, then from this menu scroll to OIL LIFE RESET. Then Press OK BUTTON. After you select the the OIL LIFE RESET the remaining PERCENT OIL LIFE is displayed.
How can I reset the fuel cut off?
This is similar to an electrical circuit breaker in your home which can be easily reset by pushing the button or pulling the leverage down. All modern fuel injection cars are equipped with an inertial fuel cut off switch that shuts off the power supply for the fuel pump if the vehicle is in a collision.
How do you reset the fuel pump switch?
The fuel pump cutoff switch has a small round button. Push the small round button to reset the fuel pump cutoff switch. Start the vehicle and allow the vehicle to run for a few seconds.
Enter your vehicle from the passenger side and locate the fuel pump shutoff switch near the underside of the glove compartment, on the lower right side. The fuel pump cutoff switch has a small round button. Push the small round button to reset the fuel pump cutoff switch. Start the vehicle and allow the vehicle to run for a few seconds.
How do you disconnect a fuel line in a Ford Ranger?
If the tool is not on hand, go onto step 2. Align the slot on the push connector disconnect tool with either tab on the retaining clip. Pull the line from the connector. 2) If the special clip tool is not available, use a pair of narrow 6-inch slip-jaw pliers with a jaw width of 0.2 in (5mm) or less.
Is there a way to reset the Ford fuel shut off?
To reset your Ford’s inertia switch, press down on the reset button. Although the location of the shut-off switch varies by year and model, Ford has stuck with a few common spots over the years.
The fuel pump cutoff switch has a small round button. Push the small round button to reset the fuel pump cutoff switch. Start the vehicle and allow the vehicle to run for a few seconds.
