How do you replace the front axle on a Chevy Silverado?
How do you replace the front axle on a Chevy Silverado?
You are hammering the spindle to break the splines of the shaft loose from the hub. There are six 15mm bolts on the axle flange at the differential. Since your truck is jacked up, when applying rotational force to the heads of the bolts, the wheel will be able to spin freely on its axis.
How do you remove a drive axle from a truck?
Remove the bolt holding the pinion pin in. Remove the pinion pin. Push the drive axles in as far as they will go. Remove the C-clips from the axles through the center of the carrier. Use the needle nose pliers and just lift them off. Once they are off, pull both axles out of the housing and stand them up.
How do you remove a rear axle cover?
Put the drip pan under the axle housing rear cover. Remove the rear axle cover with a 13mm socket. Rotate the carrier until the pinion pin side with the 7mm bolt is facing down. Line the pin up with the very edge of the opening in the axle housing so the 7mm bolt will just come out without contacting the housing.
What’s the best way to replace an axle?
Use a pair of side cutters (dikes) to remove the cotter pin from the axle snout. There might also be a star wheel which can be removed after the cotter pin. 2. Remove the Axle Nut There are three methods that can be used to loosen and remove the axle nut. The first way is what is shown by using an impact wrench which just happens to be the easiest.
You are hammering the spindle to break the splines of the shaft loose from the hub. There are six 15mm bolts on the axle flange at the differential. Since your truck is jacked up, when applying rotational force to the heads of the bolts, the wheel will be able to spin freely on its axis.
How do you change the front axle on an S-10 Blazer?
Place a floor jack underneath the lower control arm. Remove the cotter pin on the upper ball joint and loosen the ball stud nut with a socket wrench to gain access to the axle. Use a puller tool to remove the front axle from the S-10.
What kind of screwdriver do you use to remove axle bolts?
There are six 15mm bolts on the axle flange at the differential. Since your truck is jacked up, when applying rotational force to the heads of the bolts, the wheel will be able to spin freely on its axis. So to remove the bolts, position a flat head screwdriver in between three wheel studs to hold the axle in place.
How do you remove a wheel from a Chevy Silverado?
Chock the wheels on the opposite end of the truck that you are removing the wheel from. Using the tire iron, loosen the lug nuts on the wheel. Raise the vehicle using the floor jack high enough to get the wheel off. Position the jack stand under the lower control arm. Finish removing the lug nuts and then remove the wheel.
