How do you remove the brake pedal cable?
How do you remove the brake pedal cable?
From there, go inside the car, under the carpet, and pull out the rubber seal in the hole in the floor. The cable can now be pulled through this hole. The other end of the cable is attached to the brake pedal assembly by it’s end being fitted in a notch of the assembly’s pulley.
Why does my parking brake not work on my Dodge Ram?
I have a 1995 Dodge ram 2500 and my parking brake won’t set. When i push the pedal down it doesn’t lock and when I pull the release nothing happens. Any ideas??
How do you replace the brake on a Dodge Ram?
Rear brake assembly. 1. Disengage the secondary shoe return spring from the anchor pin. Figure 5. Secondary spring. 2. Disengage the primary shoe return spring from the anchor pin. Figure 6. Primary spring. 3. Push in on the hold-down retainer and turn it 90 degrees and remove the retainer, spring, and pin.
What to do if your emergency brake stops working?
The emergency (parking) brake pedal stopped working, I made a mistake of removing the emergency (parking) brake pedal assembly. So the first part of this video is good for someone who needs to fix the emergency (parking) brake pedal assembly problems. The second part of the video (rear drum brake) actually fixed my problem.
From there, go inside the car, under the carpet, and pull out the rubber seal in the hole in the floor. The cable can now be pulled through this hole. The other end of the cable is attached to the brake pedal assembly by it’s end being fitted in a notch of the assembly’s pulley.
The emergency (parking) brake pedal stopped working, I made a mistake of removing the emergency (parking) brake pedal assembly. So the first part of this video is good for someone who needs to fix the emergency (parking) brake pedal assembly problems. The second part of the video (rear drum brake) actually fixed my problem.
How to replace emergency brake front cable assembly?
Set one bolt on the drivers side to steady the brake pedal and replace the clutch mount. IF YOUR TRUCK IS STANDARD, DONT FORGET TO REATTACH THE EYELET FOR THE CLUTCH BEFORE SECURING THE MOUNT! Finish Reassembling, Connect the junction on the frame rail last. Lastly, test your new brake pedal. Service Manual Procedure attached.
Where is the parking brake assembly located on a car?
The assembly is held by 3 bolts, the middle of which can been seen and accessed only by pushing the parking brake pedal down to the floor. Otherwise it is sitting behind a metal piece attached to the pedal’s lever arm.
Do you need a new parking brake pedal?
Needed a new parking brake pedal. This one came with the brake on warning light switch, release assembly and front cable at a very good price. Keep in mind that this part is installed on the assembly line before the dash, wiring or interior is put in; lots of stuff in the way.
Where do I remove the parking brake cable?
Remove the first section of the parking brake cable under the truck. It’s the first metal joint that the two cable ends friction fit into. I found it easiest to disassemble the parking brake cable in the back of the truck where the cable attaches to the two cables going to the right and left brakes.
