How do you remove the ball joint from a lawn mower?
How do you remove the ball joint from a lawn mower?
Removing the Old Ball Joint Pull the cotter pin and loosen the large castellated nut. The top should look like a crown, or castle, at the bottom. Pop loose the ball joint. The goal is to try to guide it through the hole in the upper half of the steering knuckle. Remove the allen bolts and slide the control arm free.
How do you replace ball joint on McPherson strut?
Leave the castellated nut in place, just a few turns in to keep it in a safe place. If you’re working on a McPherson strut suspension remove the “pinch bolt” that clamps the ball joint stud. Pop loose the ball joint.
How to replace a steering knuckle hole in a soccer ball?
Guide the new joint through the knuckle hole. Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. 2 Bolt the joint into place using the hardware included.
When do you need to replace a ball joint?
There should be no space between the ball joint and the point of contact. If you see any space, or the wheel moves considerably, the joint needs to be replaced. Purchase the correct replacement ball joint assembly for your vehicle. Go to the auto parts store and get a replacement part appropriate for your make and model.
How to replace a lower control arm ball joint?
Replacing a Lower Control Arm Ball Joint. Learn how to replace a lower ball joint by pressing it out of the control arm and pressing the new one back in. To watch the longer, in depth version, click the link below. Press out a Ball Joint (In-depth):
How do you replace a ball joint on a truck?
Trucks and some cars – separate the steering knuckle from the ball joints with a ball joint fork and set aside. This process usually requires a lot of force and a BIG hammer! Carefully inspect and remove any snap rings that may be securing the ball joint in place. Using a ball joint press, press the old joint out of the control arm.
How do you remove a nut from a ball joint?
Remove the nut on the bottom of the upper ball joint using a wrench. Separate the ball joint using the ball joint separator tool. Insert the tool between the spindle and the upper control arm and hit it with a hammer until it comes loose from the spindle.
How do you replace the upper control arm?
Remove the upper control arm by removing the nuts on the engine side of the arm holding it to the frame. Use a wrench for this, but as the bolts are loosened, keep the alignment shims together that are behind each nut. It will be necessary to replace these on the side they were removed from for the alignment.
