How do you remove a radio from trim?

How do you remove a radio from trim?

You may need to wedge a flat tip screwdriver under the trim and pry up on it to remove the trim. Use a clean rag to protect the trim from being accidentally scratched while prying up on the trim. Remove the four screws holding the radio in place using a Philips head screwdriver and pull the radio out.

Can you upgrade the Satellite Radio in a suburban?

When you install a new receiver, you’ll lose factory features like XM satellite radio and navigation, if present, but you can replace and actually upgrade them if you order the right receiver. If your 2000-2002 Suburban has a rear DVD player, audio will only be available through the factory headphones.

How do you remove trim from a door panel?

Let’s Get Started. 1. Remove Small Trim Pieces. Most door panels will have small trim pieces located at the top of the panel at either the right or left side. Use a small screw driver or trim removal tool and detach (pop off) any trim pieces above the door panel. Here is an upper trim piece to the left of the panel.

How do you remove the trim panel on a Nissan Altima?

Open your Nissan Altima’s hood. Disconnect the black cable from the car’s battery with a pair of pliers or a wrench. Grip the rectangular trim panel under the radio firmly. This panel is around the air-conditioning knobs. Pull the panel firmly to remove it. Remove the four screws behind the panel with a Phillips head screwdriver.

How to remove trim panel from antenna mast?

6.1) At antenna mast, pry edge of small trim panel surrounding antenna mast releasing clip. All clips release with pry pressure. 7.1) Continue prying across top of trim panel releasing clips. 8.1) Pry edge of trim panel releasing clip. 9.1) Lift trim panel from vehicle. 10.1) Remove trim panel over antenna mast.

How do you remove an antenna from a car?

10.1) Remove trim panel over antenna mast. 11.1) With small wrench, loosen antenna mast. 12.1) Unscrew antenna mast to remove. 13.1) Use socket wrench to remove three mounting screws on antenna mast base. 14.1) Lift hood of vehicle and locate antenna bass and coax cable.

What’s the best way to replace an antenna?

Disconnect the antenna cable from the extension cable. Tie a long wire to the antenna cable. From outside of the vehicle, pull the antenna base and cable assembly until the wire can be easily accessible.

Where can I buy a GMC Sierra antenna?

Also sold under the GMC Sierra and VIA Vtrux names, available in the US, Canada, Mexico and other countries around the world. Antenna snapped off, unbolted antenna base from frame, how do I access antenna cable going to radio?

Author Image
Ruth Doyle