How do you remove a power steering seal?
How do you remove a power steering seal?
Process
- Disconnect the battery and lift the vehicle.
- Remove the power steering gear from the car.
- Clean the gearbox.
- Remove the input shaft face cover.
- Mark the cover and housing.
- Remove bearing cap bolts and cover.
- Pry the soft seal from the cap cover.
- Drive the input shaft seal with a seal driver.
What is oil seal in gearbox?
The function of the oil seal is to stop whatever fluid is inside from leaking out the clearance between the shaft and housing. The seal may also be used to prevent outside materials, such as dirt, from moving in through the clearance.
How to repair power steering gear box input shaft seal?
Please try again later. Simply needs a couple of small screws and a drill without needs of special tool. I have found this easier way of replacing the input shaft seal of a steering gear box. You don’t have to remove the steering gear box if there is enough access room to work on. Hope this help you good! Loading…
How do you remove a power steering shaft?
Lift the vehicle with a hydraulic lift or jacks and jack stands. Step 2: Remove the power steering gear from the vehicle. This step is unique to the type of vehicle you are working on, so refer to your service manual for instructions on how to remove the power steering gear from the vehicle.
Where can I get a power steering seal kit?
All power steering, gear box, rack and pinion seals are made to OEM or higher specification. Most seal repair kits have FREE SHIPPING in the USA via US Postal first class!
What’s the best way to remove a gearbox seal?
Before you remove any seals, it’s a good idea to completely clean the outside of the gear box. Using a good chemical solvent, spray the outside of the gearbox completely and remove as much debris, grime and other materials from the outside of the gearbox before disassembly.
How do you replace a power steering shaft seal?
This is the last step in replacing the power steering gear box seal. As you coat shaft seal input utilizing oil, place down the cover face; using the seal driver, install the new shaft seal then reinstall other components. You’ll need to fill the fluid reservoir of the power steering to its line indicator and reconnect the battery cables.
Before you remove any seals, it’s a good idea to completely clean the outside of the gear box. Using a good chemical solvent, spray the outside of the gearbox completely and remove as much debris, grime and other materials from the outside of the gearbox before disassembly.
How do you remove pitman arm from steering box?
Step 4: Remove the pitman arm from the steering box. Insert the pitman arm removal tool into the gap between the steering box and the retaining bolt. Using a ratchet, turn the tool’s center screw until the pitman arm releases. Tip: You can use a mallet to help in the removal of this end of the pitman arm if necessary.
How do you remove a pitman shaft seal?
Using a ratchet, turn the tool’s center screw until the pitman arm releases. Tip: You can use a mallet to help in the removal of this end of the pitman arm if necessary. Gently tap the arm or tool to pop it loose.
