How do you remove a bearing from a Silverado truck?

Place wheel chocks around the front wheels. Lift the rear of the truck with the jack and put jack stands beneath the frame and axle to support the weight of the truck. Lower the jack so the truck is on the stands completely. Put the drain pan beneath the transmission. Unbolt the straps holding the driveline to the rear axle.

How to replace rear axle bearing and seal?

Your source for a start for your DIY automotive repair. Emissions, OBD II codes, Brakes, Filters, and more. If you have a car, I probably have a video about it. ⫷ VW Jetta Brake Pads & Rotor remove and replace. A simple, low cost brake job ⫸ Videos you watch may be added to the TV’s watch history and influence TV recommendations.

How to replace rear axle seal on Chevy 2500 HD?

In this video The Disgruntled Mechanic replaces the rear axle seal on a four wheel drive with a AAM 1150 14 BOLT GM 11.5″ REAR in a 2002 Chevrolet 2500HD with the 6.6 Liter Duramax diesel engine with an Allison 1000 transmission . Should be fun! Haven’t done one in awhile! MUSIC: http://www.bensound.com/royalty-free- …

Where are the wheel bearings located on a Chevy truck?

These bearings are located within the rear axle within the diameter of the brake rotors. They are held in place by a securing lock nut and packed with grease for rotating smoothly. Under the best circumstances these bearings can last hundreds of thousands of miles.

What to do if your axle bearing comes out?

Using a axle bearing remover and a slide hammer that bearing will come out in a matter of seconds. if you have a bad axle bearing you should be able to hear some rear end noise while driving. anyways it’s beer time https://www.facebook.com/pages/Bullsh… Loading…

How do you remove a rear axle cover?

Put the drip pan under the axle housing rear cover. Remove the rear axle cover with a 13mm socket. Rotate the carrier until the pinion pin side with the 7mm bolt is facing down. Line the pin up with the very edge of the opening in the axle housing so the 7mm bolt will just come out without contacting the housing.

How do you remove a drive axle from a truck?

Remove the bolt holding the pinion pin in. Remove the pinion pin. Push the drive axles in as far as they will go. Remove the C-clips from the axles through the center of the carrier. Use the needle nose pliers and just lift them off. Once they are off, pull both axles out of the housing and stand them up.

Is it possible to remove a center support bearing?

Tip: There are a lot of people that believe it’s possible to remove the center support bearing and reattach it by using a press or other methods. In most cases, this method fails as the bearing is not properly attached or secured.

How is a center support bearing attached to a rear wheel drive car?

On some rear wheel drive vehicles, the bearing block bolts thread into nuts that are solidly mounted or welded onto the frame. On some vehicles, two part nuts and bolts are used to attach the rear of the front driveshaft to the center support bearing.

What’s the best way to replace a driveshaft bearing?

Step 2: Lubricate rusty bolts. While you are under the vehicle, take a can of WD-40 and spray a liberal amount of penetrating fluid on each bolt that attaches the driveshaft (the front and rear). Let the penetrating oil sit for 10 minutes before removing proceeding to next step.