How do you prime a Pentair Intelliflo pump?

How do you prime a Pentair Intelliflo pump?

How To Prime Your Pentair Pool Pump

1. Turn off power to pump (switch and breaker)
2. Using black 3 way valve, turn off Skimmer (main drain on only)
3. Remove pump lid.
4. Fill pump with water all the way to top.
5. Put pump lid back on.
6. Turn on Pump.

What speed should I set my variable speed pool pump?

If you are running your pool pump to filter and turn your water over, we recommend using the middle and lower speed settings. For example, for the first few days, you might run the pump at 2500 RPMs to see what your pool looks like. Next, you might dial it down to 1600 RPMs.

What RPM should I run my pool pump?

Suction cleaners typically run at around 2200-2400 RPM. Heaters require 20 to 40 Gallons Per Minute (GPM) so might run at around half speed or a little higher. You would probably want to run your Spa at up to full speed, 3450, for maximum effect.

How do I start my pool pump for the first time?

Steps to Prime Your Pool Pump

1. Turn off the pump.
2. Switch to recirculate.
3. Release air.
4. Clean out the pump basket.
5. Fill the pump basket.
6. Once the pump basket is filled and tightened, make sure the air release valve is open and turn the power to the pump on.
7. Check the water flow to your pump.

At what RPM should you run your pool pump?

What should my pool pump be set on?

The lever should be on the ‘Filter’ setting most of the time. This is the setting that provides normal pool filtration by pushing the water through the filter media (sand, glass beads or D.E) that then traps any dirt and debris before the water is returned to the pool.

How do I factory reset my Intelliflo?

Press and hold 4 top buttons then release. Then hold down the top two middle keys while holding down select and escape at the same time. Either: Turn Circuit Breaker off to the pump, wait until all the lights on the pump are out.

How does the IntelliFlo variable speed and flow pool pump work?

IntelliFlo VSF pump is the first variable speed and flow pump that adjusts to changes in flow conditions to maintain its preprogrammed flow rate to run optimally throughout the entire filtration cycle. It’s like having cruise control for your pump. Eight programmable speed or flow settings and built-in timer

How long does it take to Prime an IntelliFlo pool?

The Priming range can be set from 1 minute to 15 minutes. Note: An IntelliFlo VFmechanical seal will withstand approximately 15 minutes of attempted priming before before damage occurs. If the pool is plumbed correctly, IntelliFlo VFshould prime in less than 30 30 seconds without removing the strainer.

What does pool data mode do on IntelliFlo?

Pool Data mode is used to give IntelliFlo information about pool volume and water temperature. You also set the time clock, adjust screen contrast, and program the pump address (if needed for IntelliTouch automated control system) in Pool Data mode. Press to access Pool Data. Press to set parameters.

Which is the best variable speed pool pump?

The IntelliFlo VSF pump is the first of its kind to respond to changes in your pool’s environment in order to maintain a pre-programmed flow rate. There’s no more guesswork—just set it and forget it. The IntelliFlo VSF variable speed pool pump always delivers the precise flow for peak performance. Quietest Pump on the Planet