How do you install an air bag on a Ford truck?
How do you install an air bag on a Ford truck?
Most kits will require that you grind off a metal plate before installing the air bag’s bracketry. Figure 1. Grind off the plate outlined above if your kit mounts to the truck’s frame. Place the air bag and its mounting hardware in place on the leaf spring. Try to keep the bracket as parallel to the frame as possible.
What is the DTC code for Ford Explorer?
CODE (DTC) B141B AND/OR B141C TSB 15-0113 SERVICE PROCEDURE AIR BAG WARNING LIGHT ILLUMINATED WITH DIAGNOSTIC TROUBLE FORD: 2014-2016 Explorer ISSUE Some 2014-2016 Explorer vehicles equipped with second row inflatable seat belts may exhibit an air bag warning light illuminated with DTC B141B and/or B141C. ACTION
Are there any problems with the 2003 Ford Explorer?
The 2003 Ford Explorer has 3204 problems & defects reported by Explorer owners. The worst complaints are body / paint, transmission, and wheels / hubs problems.
Where are the air bags on a car?
Most modern passenger vehicles have one front air bag on the driver’s side of the vehicle and one on the passenger’s side; some also have side-curtain or knee-level air bags.
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
What to do when your computer is reset on your Ford Explorer?
Usually, after five starts, the light will come back on. You will need to have your vehicle serviced as soon as possible. Once the computer is reset, you will have to set the clock and any radio settings you had stored.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
How do you open the hood on a Ford Explorer?
Open the hood: release the primary latch by pulling the release lever under the steering wheel near the floor board. Once this is done, you have to release the secondary latch by sliding your hand between the grill and the hood. Pull the latch toward you. Secure it with the safety bar.
