How do you fix a high pressure air conditioner?
How do you fix a high pressure air conditioner?
If your condenser has blockage or restriction of air flow, the high pressure side reading would be high while the low side readings would drop over time. To rectify this problem, you should remove and blockage and clear any debris. After removing the debris, check the readings again.
Why does my AC compressor clutch not engage?
Why AC clutch won’t engage If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways.
How is the compressor clutch relay turned on and off?
In some vehicles the compressor clutch relay is turned on and off by the low pressure switch and the evaporator temperature sensor. In a computer controlled system, the compressor clutch relay is grounded by the computer. If the fuse is good, disconnect the electrical connector from the compressor clutch coil.
Why is the pulley on my AC compressor not working?
Check the front side of the clutch to examine its condition. Also, find out whether the clutch and the pulley are spinning. If only the pulley is rotating, the compressor clutch is having an issue, which could be stemming from several sources – a blown fuse, bad clutch oil, low-pressure lockout, or an open wire in the oil.
Why is my AC high side pressure not correct?
The correct reading will display once the clutch engages and the gauge stops cycling. If there are readings on both the high and low sides but they are not the correct specified pressures, it means that certain parts of the AC system are not functioning properly, such as the expansion valve, compressor, and clutch.
Why AC clutch won’t engage If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways.
In some vehicles the compressor clutch relay is turned on and off by the low pressure switch and the evaporator temperature sensor. In a computer controlled system, the compressor clutch relay is grounded by the computer. If the fuse is good, disconnect the electrical connector from the compressor clutch coil.
Why is the pulley not engaging the clutch?
Turn the air conditioning controls to MAX AC and start the engine. Then look at the front of the compressor clutch. Both the pulley and the clutch should be spinning. That means the clutch has properly engaged with the pulley. If only the pulley is turning, but the clutch disc isn’t, there’s a problem somewhere in the system.
Why does my car clutch not engage when low on refrigerant?
That’s why car makers install a low pressure switch–to prevent the compressor from running if the system is low on refrigerant. DIY recharging kits tell you to recharge through the low pressure port while the compressor is engaged. But if the system is low on refrigerant, the clutch will never engage.
