How do I reset my 2000 Chevy Silverado 1500?
How do I reset my 2000 Chevy Silverado 1500?
Press the accelerator pedal to the floor of the vehicle and release a total of three times within five seconds. Next, turn the ignition to the OFF position and then start the engine. If the light is off, the oil life has been reset to 100%. If it’s still on, start the process over.
How to reset the PassLock system on a 2000 Silverado?
If the Passlock system identifies the key as unauthorized, the engine stalls. Leave the ignition switch in the “Run” position as the “Security” light blinks on and off for approximately 10 minutes. Turn the ignition switch clockwise to start the engine immediately after the “Security” light stops flashing.
How to reset the change oil light in a 2000 Chevy?
by David Clair. The 2000 Chevrolet Silverado truck has an oil change reminder system connected to the onboard computer that illuminates a warning light when it is time for an oil change. If a Chevrolet dealer changes the oil in the Silverado, he or she will reset the change oil light as part of the procedure.
How to reset Chevy Silverado 1500 emission monitors?
Do not brake or shift in order to slow down. It is important to let your Silverado coast along gradually slowing down to 20 mph. The ECU will once again self-test the EGR System, EVAP Purge System and Long Term Fuel Trims. F. Accelerate: Accelerate again at 3/4 throttle until 55-60 mph is reached.
What do I need to Reset my Chevy Silverado computer?
While doing the process of rebooting the computer, you will need the OBD II car code reader. For noting down the code, you may need a pen and a piece of paper. While buying and resetting your Chevy Silverado’s computer, there are chances that so many questions come into your mind.
If the Passlock system identifies the key as unauthorized, the engine stalls. Leave the ignition switch in the “Run” position as the “Security” light blinks on and off for approximately 10 minutes. Turn the ignition switch clockwise to start the engine immediately after the “Security” light stops flashing.
How do I reset Transmission Control Module Chevy Silverado?
I have a 2001 Silverado. To reset my TCM I turn on the key to the on position press the gas pedal to the floor for 10 seconds and then turn the key off then release the gas pedal and wait about 5 minutes to restart the engine. I have a 1999 Chevy 1500 I rebuilt the transmission so when I put it in drive its like it take off in high gear.
by David Clair. The 2000 Chevrolet Silverado truck has an oil change reminder system connected to the onboard computer that illuminates a warning light when it is time for an oil change. If a Chevrolet dealer changes the oil in the Silverado, he or she will reset the change oil light as part of the procedure.
Do not brake or shift in order to slow down. It is important to let your Silverado coast along gradually slowing down to 20 mph. The ECU will once again self-test the EGR System, EVAP Purge System and Long Term Fuel Trims. F. Accelerate: Accelerate again at 3/4 throttle until 55-60 mph is reached.
