How do I know what transmission My Ford Ranger has?

How do I know what transmission My Ford Ranger has?

Since 1983, the Ford Motor Company has used about 10 transmissions for its compact Ford Ranger. The transmission identification code can be found on the vehicle’s safety compliance label on the driver’s side door post.

Are there different versions of the Ford 5R55 transmission?

Just as the title states, the Ford 5R55 Transmission has four versions. Ford 5R55 can have an N, S, or W behind those numbers. The 5R55 is a rear wheel drive 5-speed that appeared in 1999 and later vehicles. The 5R55W came out in the 2002 and later Ford Explorer and Ford Ranger models.

What kind of transmission does a Ford Ranger have?

Ford has done some switching around over the years on their ATF specs, so an easy first check is to make sure you have the right ATF installed. Have a 2002 Ranger with a 3.0 liter V6. At about 34,000 miles the auto transmission had displayed some strange shifting problems.

What to do if your Ford 5R55 is having problems?

If you have any version of the Ford 5R55 transmission and are having problems with it, don’t hesitate to bring your vehicle into The Transmission Shop to get it checked out. Having a proper diagnostic by qualified techs will eliminate the guess work and save you major expenses in the repair, rebuilding, or replacement of these transmissions.

Are there any problems with my 2000 Ford Ranger?

My Son has a 2000 Ford Ranger and is also having problems with the speedometer not working, ABS light on, and rough shifting. He changed the speed sensor but the problems didn’t go away.

I have a 2000 Ford Ranger 4X4 XLT with a 5R55E automatic transmission. Coming out of a stop the truck jolts at about 20 mph as it shifts from 2nd to 3rd gear. It feels like it revs too high in 2nd gear, up to about 2400 rpm, and then shifts hard into third.

How to fix a bad 4R55E transmission in a truck?

Now its time to button up! Go ahead and put the new separator plate on and install the 3 bolts. Torque these to 71 INCH POUNDS and then retorque them to 97 inch pounds. Now crawl under the truck and look up inside the transmission. There was a huge

When was the A4LD replaced in a Ford Ranger?

It was replaced by the 4R44E and 4R55E in 1995. The A4LD is a weak transmission, and is known to fail in offroading (4×4) applications.

What should the torque be on a 4R55E?

You will want to torque to 71 round. Torquing of the valve body is critical. You must do it in order and have a uniform torque. Below is the torque pattern: Now you can reinstall the reverse servo and cover. Then torque the bolts to 80 inch lbs and then to 115 inch pounds. install the filter.