How do I know if my electric PTO clutch is bad?
How do I know if my electric PTO clutch is bad?
“Normally” when a clutch is going bad it will start to show when you engage the PTO. A common symptom would be for the clutch to be slow to engage if it’s been running for a while and is hot. Once engaged they usually stay engaged until you shut them off.
How many volts does a PTO clutch need?
The voltage at full idle should be just below to 14+ volts in order to support the pto coil and lights. When voltage drops below 12.3, the battery light comes on, and will not go off until voltage rises above 12.7. You may also want to make sure the battery can take a load.
What would cause a PTO to not engage?
Two common reasons that a PTO won’t engage are installation issues and owner misuse. Addressing these possibilities first might be the only thing needed. Additional problems could arise if the switch is showing no continuity. Check for continuity using a multimeter.
Why won’t my Cub Cadet blades engage?
Common solutions for: Cub Cadet Lawn mower blades won’t engage. If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Why won’t my lawn mower blades engage?
Belt-the number one cause for your blades not to engage is that your belt is either stretched or loose causing it to slip or fall off completely. Belt could have snapped also. When you are trying to process too much grass/leaves they could pack up under your deck and push off your belt.
How do you know if your PTO switch is bad?
Simple test would be to remove the mower deck belt from the PTO pulley and try to engage the PTO. If it doesn’t stall, the clutch is not your problem. If it does stall I would guess you’ve had a bearing fail in the clutch. The other thing to check is the seat switch if it’s still enabled.
Why does my PTO keep turning off?
@mattk ,Matt, Something as simple as a low battery/bad connection or not charging could cause this. Possibly bad seat/reversing safety switch, faulty/loose wire/plug to clutch/PTO/switch, clutch faulty. Trouble shooting/parts/manual links below may help.
Why won’t my Cub Cadet blades won’t engage?
