How do I adjust the transmission shifter cable?
How do I adjust the transmission shifter cable?
Place the transmission in park and apply the parking brake. Raise and support the vehicle on jackstands. On the shift cable end slide the black retaining clip forward just enough to allow the white lock button to be out. Do not push the white lock button completely out.
Where is the shift cable in a Chevy?
Take the rubber boot off the gear shift inside the vehicle and lift it up, exposing the area where the gear shift and the transmission connect. Look for the shift cable and the shifting arm. A single bolt and nut connect the shift cable and shift arm. Twist the nut connecting the gear shift and the transmission.
How do I adjust the transmission cable on my 1995?
Place the shift lever in park and turn the ignition switch OFF . Raise and support the vehicle on jackstands. Make sure the transmission is in mechanical park by rotating the control lever clockwise until it stops.
What to do when your shift cable snaps?
When a shift cable snaps, the gear shifter can no longer switch from gear to gear. Take the rubber boot off the gear shift inside the vehicle and lift it up, exposing the area where the gear shift and the transmission connect. Look for the shift cable and the shifting arm. A single bolt and nut connect the shift cable and shift arm.
Where is the automatic shifter cable on a Silverado?
If you are having issues shifting in or out of park or L ,your shifter cable may be getting bad.On Silverado-Sierra trucks the automatic shifter cable comes up through the floor and is under the carpet on the drivers side.Because the drivers feet is always on the cable they seem to go bad a lot on Silverado-Sierra trucks.
Can you change shift cable on Chevy Escalade?
This video can also be used as a guide to change a shift cable if you have a Sierra, Suburban, Yukon and Escalade with a similar GMT800 platform. The shift cable on the Silverado, Sierra, Suburban, Yukon and Escalade commonly fail due to stretching and cable housing damage.
Why does the shift cable on my Yukon fail?
The shift cable on the Silverado, Sierra, Suburban, Yukon and Escalade commonly fail due to stretching and cable housing damage. If you find that you are having issues shifting into gear or removing your key from the ignition then you should inspect your shift cable for any signs of wear or damage.
What kind of transmission cable do I Need?
ACDelco GM Original Equipment Automatic Transmission Shifter Cable is a GM-recommended replacement component for one or more of the following vehicle systems: automatic transmission/transaxle, and/or manual drivetrain and axles.
What are the parts for a 2000 Chevy Silverado?
Click on View All to view each individual Chevrolet 2000 Silverado 1500 part. The CF-WHGM2 is a multi colored turbo wire harness that comes with a full manufacturer warranty. This harness will Fit multiple makes and models. K would buy this again if needed. K would buy this again if needed. I hooked this up in about 15 minutes and it is great.
What’s the best way to move the shift lever?
Raise and support the front end on jackstands. Block the rear wheels. Loosen the shift lever bolt or nut at the transmission lever so that the lever is free to move on the rod. Set the column shift lever to the neutral gate notch, by rotating it until the shift lever drops into the Neutral gate.