How do I add a backup camera to my Silverado?
How do I add a backup camera to my Silverado?
Using a small screwdriver, separate some of the strands of the stripped wire, and splice in the power cable for your backup camera to them. Usually, you can do this by looping the wires together. Make sure positive is connected to positive and negative is connected to negative.
Where is the backup camera on a car?
The black wire will connect to chassis ground and the yellow RCA cable will connect to the backup camera input on the back of the radio, and we’re going to run these wires underneath these panels here, down next to the backseat underneath the door sills, right up to the driver’s kick panel up into the dash, and right out into the radio cavity.
Is it easy to install a backup camera?
Installation is straightforward, and you can do it yourself if you’re even just a little handy. In this video, our expert walks through a typical backup camera installation, and provides many great tips to help your installation be a success.
How can I add a backup camera to my reverse light?
Strip the positive and negative wires on your reverse lights (make sure your truck is powered off before you do this). Using a small screwdriver, separate some of the strands of the stripped wire, and splice in the power cable for your backup camera to them. Usually, you can do this by looping the wires together.
How to wire a back up camera system?
We explain vehicles with light control modules and the problems they pose. Then we make the connection at the taillight to a back up camera system. We recommend using a relay whenever wiring a back up camera system to isolate the system from the light control modules. Please leave your comments and questions below. Loading…
Where do you run the camera on a Silverado?
Run the camera and power cable through the hole into the interior of your truck. On a Silverado, removing the panels near the base of each passenger side door should be a convenient place to run the wires. Connect the RCA cable to the camera’s cable, and run it all from the rear to the fuse box at the front of the truck.
Using a small screwdriver, separate some of the strands of the stripped wire, and splice in the power cable for your backup camera to them. Usually, you can do this by looping the wires together. Make sure positive is connected to positive and negative is connected to negative.
Strip the positive and negative wires on your reverse lights (make sure your truck is powered off before you do this). Using a small screwdriver, separate some of the strands of the stripped wire, and splice in the power cable for your backup camera to them. Usually, you can do this by looping the wires together.
We explain vehicles with light control modules and the problems they pose. Then we make the connection at the taillight to a back up camera system. We recommend using a relay whenever wiring a back up camera system to isolate the system from the light control modules. Please leave your comments and questions below. Loading…
Run the camera and power cable through the hole into the interior of your truck. On a Silverado, removing the panels near the base of each passenger side door should be a convenient place to run the wires. Connect the RCA cable to the camera’s cable, and run it all from the rear to the fuse box at the front of the truck.
