Do you need to remove dash cluster on Corvette?

Do you need to remove dash cluster on Corvette?

These do not require removal unless you need to remove the dash cluster after dash pad removal. This is one of several tabs that keep the dash in place and you do not want to miss one of them.

How do you remove the dash flasher on a corvette?

The four way flasher button pulls off with a couple of small screwdrivers prying it outward. The tool is in place from the underside of the dash ready for the screwdriver to push the tab from the bottom up. Once the flasher is out of the plastic housing it must be coerced over enough to remove the connector.

Where are the sensors on a Corvette dash?

There are two sensors, sun load and ambient light, one on each side. Remove the two 7mm screws at the top of the dash. Remove the7mm screw on the right side of the dash near the door jamb. Pop off these access covers inside the glove box with a flathead screwdriver to access the screws behind them.

How do you remove photo sensor from Corvette?

Remove the 7mm screw on the left side of the dash. Pop up the defroster vent with a flathead screwdriver to access the photo sensor. Gently twist the connector to remove it. There are two sensors, sun load and ambient light, one on each side. Remove the two 7mm screws at the top of the dash.

These do not require removal unless you need to remove the dash cluster after dash pad removal. This is one of several tabs that keep the dash in place and you do not want to miss one of them.

There are two sensors, sun load and ambient light, one on each side. Remove the two 7mm screws at the top of the dash. Remove the7mm screw on the right side of the dash near the door jamb. Pop off these access covers inside the glove box with a flathead screwdriver to access the screws behind them.

The four way flasher button pulls off with a couple of small screwdrivers prying it outward. The tool is in place from the underside of the dash ready for the screwdriver to push the tab from the bottom up. Once the flasher is out of the plastic housing it must be coerced over enough to remove the connector.

Remove the 7mm screw on the left side of the dash. Pop up the defroster vent with a flathead screwdriver to access the photo sensor. Gently twist the connector to remove it. There are two sensors, sun load and ambient light, one on each side. Remove the two 7mm screws at the top of the dash.