Do you have to torque spark plugs?
Do you have to torque spark plugs?
Spark plugs, should be torqued to manufacturers specifications. However, it is possible to tighten the plugs satisfactorily without a torque wrench. Tighten new or reused gasket spark plugs as follows: Hand tighten the spark plug until it seats.
How do you change spark plugs on Dodge Nitro?
When the manifold is gone it is now very easy to reach the plugs and do the swap. Just disconnect the electrical wires, remove the retaining bolt on the coil and slip the coil out of the well. Then use an extension and plug socket to remove the plugs one by one.
What kind of engine does a Dodge Nitro have?
The 3.7 liter (226 CID) six-cylinder engine is an 90° single overhead camshaft engine.
Can you remove the intake from a Dodge Nitro?
When all hoses and nuts/bolts are loosened and removed you can carefully remove the intake. You will have to wiggle it around a bit to slip it free and watch the metal hose on the passenger side as it slides into the manifold about 3-4″s (also watch this when mounting the manifold when done).
Where is the serial number on a Dodge Nitro?
The cylinders are numbered from front to rear with the left bank being numbered 1, 3, and 5 and the right bank being numbered 2, 4, and 6. The firing order is 1-6-5-4-3-2. The engine serial number is located at the right front side of the engine block.
Where are the spark plugs on a Dodge Nitro?
The cylinders are numbered from front to rear, with the right bank odd numbered, and the left bank even numbered The firing order is 1-2-3-4-5-6. The engine identification number (2) is located on the rear of engine block just below the left cylinder head I can’t locate th spark plugs in my 2007 Nitro to replace them and what plugs are best?
The 3.7 liter (226 CID) six-cylinder engine is an 90° single overhead camshaft engine.
When all hoses and nuts/bolts are loosened and removed you can carefully remove the intake. You will have to wiggle it around a bit to slip it free and watch the metal hose on the passenger side as it slides into the manifold about 3-4″s (also watch this when mounting the manifold when done).
The cylinders are numbered from front to rear with the left bank being numbered 1, 3, and 5 and the right bank being numbered 2, 4, and 6. The firing order is 1-6-5-4-3-2. The engine serial number is located at the right front side of the engine block.
