Can you change the throttle on a Dodge Ram 1500?

Contacted Dodge to see if they could do anything of coarse the answer was “NO”. Even though the soot must have been building up before the light came on. I would like to know how many people this has happened to.

Is there an issue with service electronic throttle control?

I have a issue with my 2016 Eco-diesel. I lost acceleration at points in my driving and then got a message ” Service Electronic Throttle Control ” I have 113000 km on my vehicle so warranty is up by 13000 km. Dealership said it was going to be a $4800.00 fix. Contacted Dodge to see if they could do anything of coarse the answer was “NO”.

Why is my EcoDiesel throttle control not working?

Click to expand… Has this continued to happen? Just curious if this was a fluke or an electrical failure.

How do I reset the Dodge Ram throttle position sensor?

To reset the Dodge Ram throttle position sensor, you turn on the ignition without your foot on the brake, so the engine doesn’t start. Press the accelerator on the floor for 15 seconds. Release the accelerator, then turn the car off and start the engine and drive.

Is there a problem with the throttle on a Dodge Ram?

I noticed a red lightening bolt on dash lit up. Looked it up , and manual says ETC (electronic throttle control error) Shortly after truck died. Restarted would only roll 3-5 mph throttle responded to nothing. Turned off and back on truck ran fine still have red light . Purchased new throttle position sensor from dealership still not corrected.

Click to expand… Has this continued to happen? Just curious if this was a fluke or an electrical failure.

What causes the throttle control light to go on?

The engine computer is programmed to go into limp mode when the system malfunctions, in an attempt to limit your speed and prevent damage to the engine. It can be caused by a sensor failure, or even by outside electromagnetic interference. Your mechanic can diagnose and fix the problem. Can I drive with the throttle control light on?

Why does my throttle control go into limp mode?

Solution: This indicates a serious failure of your throttle control system. The engine computer is programmed to go into limp mode when the system malfunctions, in an attempt to limit your speed and prevent damage to the engine. It can be caused by a sensor failure, or even by outside electromagnetic interference.

Is the Check Engine light still lit on Dodge Ram?

This article applies to the Dodge Ram 2nd, 3rd, and 4th Generation (1994-Present). It’s not uncommon for a check engine light to remain lit long after the issue setting it off in the first place has been fixed.

How does the electronic throttle work on a truck?

If your truck has a 5.7L Hemi, it becomes even more critical as this engine requires maximum control. The ETC’s whole job is to collect information from the accelerator (sensor in the pedal) and adjust the throttle accordingly. When you press the pedal on the truck, the electronic throttle receives a signal from the sensor.

What does etc light on Dodge Ram mean?

One of the most typical issues owners of the Dodge RAM truck tend to suffer is the ETC light flashing out of nowhere. When this happens, it means the electronic throttle control is damaged or malfunctioning – so it is time to repair. But learning how to fix the electronic throttle control 5.7L Hemi engine is not an easy job.

How to replace the throttle on a car?

To replace it a first open the engine hood and find out the throttle control part on top of the engine, connecting the air filter. Now take any screwdriver suitable to the screws and loosen the bolt and then sway a little and take it out. On one side of the throttle body, you will see an electric connection hose pipe.

Can you change the throttle on a Dodge Ram 1500?