Can you change the piston rings without removing the Pistons?
Can you change the piston rings without removing the Pistons?
In many cars, you cannot change the piston rings without removing the pistons. Generally, it can vary from car to car. Therefore, get your hands on the service manual to understand the concept in detail. In a well-ventilated area, use some kerosene and soak all the removed pistons into it.
How can you tell if your car has bad piston rings?
If there is a lot of exhaust smoke coming out of your vehicle, this could be an easy sign that you have bad piston rings. This smoke will look very thick and have dark gray and blue colors to it. It is often accompanied with a burning oil smell. When you have bad piston rings, engine oil will start leaking into the combustion chamber.
Why does my Chevy Silverado make a knocking noise?
65 people found this helpful. for a piston slap you need to pull apart the motor and possibly either re-bore the cylinder with the bad piston or replace the entire block be cause of the damage done to the piston and the cylinder as the piston “slapped” against the walls of the cylinder most likely gouging the cylinder walls
How are pistons used in a combustion engine?
Most combustion engines have pistons. Pistons, along with the closed valves in the head, are used to seal the combustion chamber while the air fuel mixture is igniting on the combustion stroke. As the air fuel mixture ignites, it forces the piston down the cylinder bore.
Why does my Silverado lifter burn so much oil?
Engines with AFM use a high-volume oil pump. When you eliminate the AFM system, the extra oil is no longer needed. Excess oil will be pushed out of the pressure relief valve into the oil pan. This will spray oil on the bottom of the cylinder walls which can cause oil burning, especially in high-rpm engines.
65 people found this helpful. for a piston slap you need to pull apart the motor and possibly either re-bore the cylinder with the bad piston or replace the entire block be cause of the damage done to the piston and the cylinder as the piston “slapped” against the walls of the cylinder most likely gouging the cylinder walls
Are there any issues with my Chevy Silverado?
Never had issues as long as I treated them right. the 57 Ford refused to break, the 51 Plymouth kept spinning rod bearings. Beat you vehicle, and keep shelling out money. 14 people found this helpful.
Where is the idle control valve on a Chevy Vortec?
The idle control valve sits on the throttle body and is responsible for adjusting the amount of air that enters the engine at idle, ultimately controlling engine idle speeds. At idle, the valve blocks a small amount of air from entering the engine, keeping idle RPM’s low.