Can a Silverado clunk over a bump?
Can a Silverado clunk over a bump?
Clunk at low speeds over bumps front end pass side. 07 Silverado NBS Checked the X-member bolts i was able to tighten them by hand initially. Torqued both sides to 70Ft/lbs, no more clunk. . Tightened the 18mm Xmember bolts, got 3/4 turn out of the driver’s side and about a 1/2 turn on the passenger side.
Why is my front end clunking on the road?
We’ll be able to diagnose and fix your front end clunking quickly and efficiently. Front end suspension is always taking some extreme abuse from pot holes and poorly maintained road, so it will probably require some adjustment at times. Letting it go may only create problems in the future.
Why does my GM car make a clunking noise?
If you aren’t really sure how to check your GM vehicle’s suspension system for the noise that you know is coming from “somewhere up there”, go ahead and bring in your car at anytime. We’ll be able to diagnose and fix your front end clunking quickly and efficiently.
Why does my right sway bar make a clunking noise?
Right sway bar link 2 flats loose. Added a little blue loc-tite to both sides and no issues since. If it sounds like it’s near your feet, there is a tsb for it. Something about a body mount.
Clunk at low speeds over bumps front end pass side. 07 Silverado NBS Checked the X-member bolts i was able to tighten them by hand initially. Torqued both sides to 70Ft/lbs, no more clunk. . Tightened the 18mm Xmember bolts, got 3/4 turn out of the driver’s side and about a 1/2 turn on the passenger side.
We’ll be able to diagnose and fix your front end clunking quickly and efficiently. Front end suspension is always taking some extreme abuse from pot holes and poorly maintained road, so it will probably require some adjustment at times. Letting it go may only create problems in the future.
How do I fix a clunk in my front suspension?
Apply a light coat of automotive adhesion promoter to the top of the dust boot (shield) on the inside edge and to the top of the bumper. Allow to dry 10 minutes. 3. Glue the bumper to the inside of the dust boot (shield) as shown. Use fast curing adhesive. Allow to cure thoroughly 5-10 minutes at room temperature.
If you aren’t really sure how to check your GM vehicle’s suspension system for the noise that you know is coming from “somewhere up there”, go ahead and bring in your car at anytime. We’ll be able to diagnose and fix your front end clunking quickly and efficiently.
