Can a rear drum be removed on a Ford Fiesta?
Can a rear drum be removed on a Ford Fiesta?
Putting the wheel on for extra leverage will definitely wreck the bearing as you won’t pull it squarely. A hub puller is the safest way. On my 7.5 fiesta the rear drums are held on by two screws just remove screws and drum comes off, or is mine an update from earlier versions. mk7.5 is different (and much easier).
Why are my brakes not working on my Mk6 Fiesta?
I need to change my brake shoes on a Mk6 Fiesta, but can not get the drum off. I’ve removed the bearing nut and the drum will rock back and forward. I think what has happened is that the shoes have worn a groove into the drums and the shoes are not able to get off the lip.
How to remove a brake drum that is stuck on?
Watch how to remove a brake drum that is stuck on. I go through the steps so anyone can remove their drum brake. In this case the drum adjuster was stuck so first try to get it off by wiggling back and forth. Then spray penetrating oil to remove rust between the drum and the seat. Then hit it with a hammer hard.
I need to change my brake shoes on a Mk6 Fiesta, but can not get the drum off. I’ve removed the bearing nut and the drum will rock back and forward. I think what has happened is that the shoes have worn a groove into the drums and the shoes are not able to get off the lip.
Can a drum brake be removed from a Fiesta?
It’s common for the drum to wear and form a lip which stops it sliding off the brake shoes, which might cause confusion, but I would be a bit surprised to find a radically unconventional setup on something as mundane as a Fiesta? You don’t undo the pack nut unless your replacing the wheel bearings.
How do you remove a rear brake drum?
Rear brake drum removal. The ‘nut’ holding the wheel bearing is a pack of 4 thin nuts held together by a claw type washer. How do you get the nut off?? ideas anyone? Do not understand. Are you sure it is a stack of thin nuts and not just one ordinary nut with indentations on the corners?
Can you remove pack nut on Ford Fiesta?
You don’t undo the pack nut unless your replacing the wheel bearings. The nut is torqued to +200lbft and removal will render the nut useless, it can also strip the threads on the stub shaft if it’s undone too often.
What’s the best way to remove a brake drum?
Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum. Do not over-tighten the screw on the brake drum puller. Knock the back of the brake drum lightly with a hammer. Tap the hammer against the brake drum with an outward motion.
What happens when you change the drum on a car?
Most drum brakes on cars and other common vehicles are hydraulically powered. If there is a leak in the hydraulic system, you may notice fluid inside the drum and on the brake shoes. Usually, this is accompanied by decreased brake performance. If necessary, replace the leaky wheel cylinder.
How do you remove rear drum brake on Ford Fiesta?
Using a puller ensures the bearing is pulled square to avoid damage. You can do it by wedging screwdrivers and chisels around the edge of the drum to lever it off but this often does damage the bearing. Can you leave the wheel on the studs and use it as leverage or is that a nasty idea?
Use a screwdriver to attach the brake drum puller’s screw tightly. Tighten the screw until the brake drum puller is securely fastened around the brake drum. Do not over-tighten the screw on the brake drum puller. Knock the back of the brake drum lightly with a hammer. Tap the hammer against the brake drum with an outward motion.
Most drum brakes on cars and other common vehicles are hydraulically powered. If there is a leak in the hydraulic system, you may notice fluid inside the drum and on the brake shoes. Usually, this is accompanied by decreased brake performance. If necessary, replace the leaky wheel cylinder.
