Can a mobile mechanic diagnose a faulty water pump?

There are some vehicles that will not allow you to see the water pump without removing the timing cover and this is a lengthy process. If this is the case with your vehicle, it is best to have one of YourMechanic’s certified mobile mechanics look over your car for proper diagnosing.

What to do if your water pump is not working?

If the coolant isn’t circulating or if there is no coolant to circulate, the heater can’t do it’s job of keeping the inside of your car warm. This is a sign to pull over safely and turn off your engine. Step 4: Check water pump pulley. With the engine off, open your hood and locate the water pump pulley.

Why is there a weep hole in my water pump?

If this is the case with your vehicle, it is best to have one of YourMechanic’s certified mobile mechanics look over your car for proper diagnosing. Note: Leaks at the weep hole or at the water pump gasket are typically caused by contaminated coolant (or dirty coolant).

How to tell if your car water pump needs replacement?

Part 1 of 2: How to tell if a car’s water pump needs replacement. There should be no movement, if there is, this along with the noise is a good indication you may have a water pump problem. Step 5: Check for leaks. It is possible to see signs of coolant leaking before you experience your vehicle’s engine overheating.

What should I do if my water pump is not working?

While you must ensure the filter is fine enough to prevent damaging solids from entering the pump, too fine a filter for the water pump will restrict the flow right as the water enters the intake. Be sure the filter is proper for the pump. Centrifugal water pumps are designed to operate with the impeller going in one direction.

What kind of wrench do you need to replace a water pump?

There are five T30 bolts holding the water pump onto the housing and you will need an L handle torx (i.e. like an allen wrench) to fit in there. The locations are shown in the first photo. Access was tight but not horrible. The second photo shows the water pump detached in situ.

What happens if you use a utility pump in a waterfall?

Make sure you are not using a utility pump in a pond or waterfall. Submersible utility pumps may overheat from running in water that is too shallow. Submersible utility pump motors are cooled by the water that surrounds them. Without enough water, they will overheat. Make sure you are not using your utility pump in a fish pong.