Are there any problems with the liftgate on a GMC Acadia?
Are there any problems with the liftgate on a GMC Acadia?
Make and Model > GMC Trucks > Acadia > Power liftgate problems on… GM has issued a service bulletin to address power liftgate problems on Enclave, Traverse, Acadia, and Outlook vehicles listed below. GM has documented the following power liftgate problems and their causes
Why is the power latch on my Acadia not working?
The original post was really helpful. Just ran into the same issue with my 2008 Acadia where the latch stopped working ( the power lift and close hasn’t worked for a year ) and after replacing the power latch, the power lift/ close is working again also! Just a couple updates:
Why is my GMC power liftgate not working?
The liftgate all of a sudden stopped latching (locking) so had to bungee cord it to keep it closed since I was on the running errands. I could hear the motor (actuator) operating but the latch just does not engage, which leads me to believe the entire mechanism is faulty.
Why does power liftgate open and close slowly?
Power liftgate closes immediately after fully opening. Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. Possible Causes and fixes: 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly).
The original post was really helpful. Just ran into the same issue with my 2008 Acadia where the latch stopped working ( the power lift and close hasn’t worked for a year ) and after replacing the power latch, the power lift/ close is working again also! Just a couple updates:
The liftgate all of a sudden stopped latching (locking) so had to bungee cord it to keep it closed since I was on the running errands. I could hear the motor (actuator) operating but the latch just does not engage, which leads me to believe the entire mechanism is faulty.
How can I Fix my power lift gate?
So here’s how you fix it: You can now pull the plastic body panel off the inside of the gate. It will require you to pull hard, be careful to disconnect the two electrical harnesses near the latch mechanism before removing the panel completely from the car. Assemble in the opposite order.
How to disable the power liftgate on a GM car?
1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.
Are there any problems with the liftgate on the GM enclave?
GM has issued a service bulletin to address power liftgate problems on Enclave, Traverse, Acadia, and Outlook vehicles listed below. GM has documented the following power liftgate problems and their causes
How do I open the lift gate on my Denali XL?
Use a 1 1/16″ drill bit to drill a hole through the trim panel in the dimple area. Use a flat blade tool (i.E. Screwdriver) to push down on the black bell-crank lever through the plug hole to unlock the lift-gate. Push open the lift-gate from the inside. helpful? I am experiencing the same problem on my 2007 Yukon Denali XL.
Make and Model > GMC Trucks > Acadia > Power liftgate problems on… GM has issued a service bulletin to address power liftgate problems on Enclave, Traverse, Acadia, and Outlook vehicles listed below. GM has documented the following power liftgate problems and their causes
When did the latch stop working on my Acadia?
Just ran into the same issue with my 2008 Acadia where the latch stopped working ( the power lift and close hasn’t worked for a year ) and after replacing the power latch, the power lift/ close is working again also! Just a couple updates: My old latch part# was 13502698 which was superseded by 13581405.
Where is the disable switch on GM power liftgate?
Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack.
Power liftgate closes immediately after fully opening. Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. Possible Causes and fixes: 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly).
What happens when you power close the liftgate?
Power liftgate closes immediately after fully opening. Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly).
1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.
GM has issued a service bulletin to address power liftgate problems on Enclave, Traverse, Acadia, and Outlook vehicles listed below. GM has documented the following power liftgate problems and their causes
Power liftgate closes immediately after fully opening. Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly).
