Why is the reverse clutch not working on my 4L60E?
Why is the reverse clutch not working on my 4L60E?
If the pan looks good, and the fluid looks clean, than it’s likely not going to be the low reverse clutch causing the problem. Valve Body Issues- A bad valve body can make the reverse gear not work in the 4L60E. If the valve body ends up warped, or if the gasket fails, it’s entirely possible that the gear won’t engage.
What happens if there is no reverse in a transmission?
In the case of “No Reverse,” the players inside the transmission are: Low/Reverse Band (also used for engine braking in manual 1st gear) Knowing this, we want to test the line pressure while in Reverse, 3rd gear, 4th gear and in manual 1st.
Why does the engine stall when I put the car in reverse?
If the engine stalls, it may be caused by a faulty idle control valve, bad O2 sensors, or clogged fuel injectors. In regards to the “pan”, we’re not sure what you are referring, so it may be a good idea to contact one of our local professional mechanics to complete a battery inspection to determine what’s going on with your 2010 Ford Focus.
What happens when I put the car in reverse?
Put the car in reverse holding the brake the car stalls, if I go into neutral or drive it works fine. If I put the car in reverse not holding the brake it shifts rough but doesn’t stall. I have not driven the car at speeds higher than 35mph, so not sure of the other gears.
If the pan looks good, and the fluid looks clean, than it’s likely not going to be the low reverse clutch causing the problem. Valve Body Issues- A bad valve body can make the reverse gear not work in the 4L60E. If the valve body ends up warped, or if the gasket fails, it’s entirely possible that the gear won’t engage.
Put the car in reverse holding the brake the car stalls, if I go into neutral or drive it works fine. If I put the car in reverse not holding the brake it shifts rough but doesn’t stall. I have not driven the car at speeds higher than 35mph, so not sure of the other gears.
What causes a truck to Buck and sputter?
It would not kick back down or downshift properly. It would just cause the engine to rev and rev. But after about 10mins of that, it went away. The truck drove fine….except when I was going on a steep steep steep hill. It did sputter and buck just a little bit.
What makes a 2004 Lincoln LS sputter and hesitate?
SOURCE: My 2004 Lincoln LS is sputtering/hesitating. It could be your coils? You can’t post conmments that contain an email address. Hesitation under heavy acceleration: 1st gear @ 20mph, 2nd gear @ 30mph, accelerates nicely to these points, then abruptly hesitates as if ‘bogging’ down.
Why does my 4L60E have no reverse?
Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell.
What causes a truck to stall in reverse?
For the last few months, my truck has been stalling when shifting it into reverse from drive. If I go to say, parallel park, within a second or two of changing gears from drive to reverse, the RPMs drop significantly and then it stalls.
What causes a WoT Shudder on a 4L60E?
3. 1-2 Shift shudder at WOT (Wide Open Throttle); delayed or abnormal 1-2 shift; There’s a problem ONLY on the 1-2 shift: 1-2 accumulator piston cracked or stuck cocked in the bore. Check the yellow spring inside the accum housing for breakage.
What happens when you shift into reverse transmission?
Stalls When Shifting Into Reverse – Transmission Going? Discussion in ‘ Transmission & Drive train ‘ started by Rebecca, Sep 26, 2011 . I’m new (just posted my intro in “New Member” section) and I am in need of some advise/guidance.
