Why is my skid steer not working properly?
Why is my skid steer not working properly?
If it is not less than 5 ohms resistance in the wires from the ecm to the solenoid or the detent , wiring harness is the problem. If it is less than 5 ohms, the ecm could be the problem. Remove the ecm and try it in another machine to see if you get the same fault before replacing the interlock ecm.
Why does the bucket on my tractor not uncurl?
While using the tractor the other day, I accidentally dug the edge of the bucket into the ground while driving forward at speed. The hit was pretty hard, and my chest slammed into the steering wheel. After that impact, the bucket no longer un-curls. It curls fine.
Why does my bucket not uncurl when I hit it?
After that impact, the bucket no longer un-curls. It curls fine. It goes up and down fine, but if you try to uncurl, it moves about 1 inch and then stops. I tried reversing the hydraulic lines (curl hydraulic circuit to lift cylinders, and vice versa), and the curl feature then works fine. So there is nothing wrong with the curl cylinders.
Can a skid steer go forward or backward?
Skid steer..The lift arms and bucket hydraulics will not operate… I have a CAT 277… I have a CAT 277 track skid steer. It will travel forward and backward. The lift arms and bucket hydraulics will not operate. The door has been removed and the wires spliced for the safety switch. There is no pump noise when operating the controls.
While using the tractor the other day, I accidentally dug the edge of the bucket into the ground while driving forward at speed. The hit was pretty hard, and my chest slammed into the steering wheel. After that impact, the bucket no longer un-curls. It curls fine.
After that impact, the bucket no longer un-curls. It curls fine. It goes up and down fine, but if you try to uncurl, it moves about 1 inch and then stops. I tried reversing the hydraulic lines (curl hydraulic circuit to lift cylinders, and vice versa), and the curl feature then works fine. So there is nothing wrong with the curl cylinders.
What happens to the bucket when you hit the steering wheel?
The hit was pretty hard, and my chest slammed into the steering wheel. After that impact, the bucket no longer un-curls. It curls fine. It goes up and down fine, but if you try to uncurl, it moves about 1 inch and then stops.
Why is the lift and curl valve not working?
This is because it has a piloted check valve in the lift and curl circuits. If you damaged the piloted check valves, that would explain why the rod side of the cylinder will not depressurize. Maybe damage to the spool valve?
