Why does the recirculate air button never stay on?
Why does the recirculate air button never stay on?
You go to hit the recirculate air button on the ac/heat control and It blinks a few seconds then goes off. Never stays on. Any ideas? It is supposed to do that. If I remember right, it only stays on when the A/C is on. If I remember correctly it’s telling you there is a controller error. You need a professional scan tool to pull a/c codes.
Can a recirculate air button be used in defrost mode?
Recirculation cannot be used in floor, blend or defrost modes. An indicator on the button will light up, flash three times and turn off when recirculation is selected in these modes.The air-conditioning compressor will also come on when this mode is activated. While in recirculation mode the windows may fog when the weather is cold and damp.
Why does the a / C button flash on and off?
I got the flashing A/C light and was like, “*****!” This system is dumb. Re: A/C Button Flashes? If the truck thinks its below 40 degrees outside, your AC will not be allowed to come on to protect the compressor. Go figure!! The darn AC light will just flash on and off.
When do I press the AC button it blinks three times?
If the vehicle is equipt with an ambient air temperature display, the sensor also prevents the AC clutch from engaging if the outside air is below as certain tempreture. To test, turn the AC on. Press and hold the AC button at the same time as you press and hold the recirculate button. Hold for 5 to 8 seconds.
Recirculation cannot be used in floor, blend or defrost modes. An indicator on the button will light up, flash three times and turn off when recirculation is selected in these modes.The air-conditioning compressor will also come on when this mode is activated. While in recirculation mode the windows may fog when the weather is cold and damp.
You go to hit the recirculate air button on the ac/heat control and It blinks a few seconds then goes off. Never stays on. Any ideas? It is supposed to do that. If I remember right, it only stays on when the A/C is on. If I remember correctly it’s telling you there is a controller error. You need a professional scan tool to pull a/c codes.
If the vehicle is equipt with an ambient air temperature display, the sensor also prevents the AC clutch from engaging if the outside air is below as certain tempreture. To test, turn the AC on. Press and hold the AC button at the same time as you press and hold the recirculate button. Hold for 5 to 8 seconds.
Why does the recirculation switch Flash 3 times?
If the recirculation switch is pressed into the ON position when the mode switch is in an unavailable mode position, then the recirculation switch LED will flash 3 times.
