Most popular

Why does my PT Cruiser shake at idle?

Why does my PT Cruiser shake at idle?

These packs are fired by the engines computer at exactly the right time to provide the optimal ignition timing. If a coil pack goes bad, it’ll cause a misfire and rough idle condition. Really, your PT Cruiser will be running rougher at any RPM, but a misfire will be most pronounced at idle.

Is there a problem with the PT Cruiser radiator?

112 people found this helpful. Our 2006 was doing this, found that there is a problem with PT radiator fans, they have two speeds and the low speed often burns out, you can crawl under there disconnect the power and add power and ground to 2 pins then try the other pin, mine wouldnt work on one speed but would did on high. Google this.

What makes a PT Cruiser run too lean?

Of all the sensors equipped in your vehicle, the O2 sensors may have it the hardest. They deal with super hot exhaust that can cover them in deposits that can leave them ineffective. The heat of the exhaust can also bake the wiring going to/from them over time. If an oxygen sensor goes bad, it can make your PT Cruiser run too lean (or rich).

What should I do about my PT Cruiser overheating?

Checked debris between condensor and fan, fan works, coolant full, thermostat works, all relays good, changed egr valve and thoroughly cleaned egr tubing, no cracked head or head gasket problem. Getting to my wits end and ready to take long drive off short pier. Any ideas what’s wrong or what else I could do to fix this problem?

What to do if your PT Cruiser is idle?

If either of these error codes appears, then take your PT Cruiser to the dealer to have the idle speed control motor inspected. If no error codes related to the idle speed motor come up, replacing your spark plugs could resolve your idle issues.

Why does my Chrysler PT Cruiser shake when idling?

Here are the main components of the ignition system, as well as what would cause them to make your PT Cruiser shake when idling. Fouled plugs can cause a misfire, which in turn causes an idle shake. Spark Plugs – One of the absolute most common causes (if not the most common reason that your PT Cruiser may be shaking) is the spark plugs.

Are there any problems with the Chrysler PT Cruiser?

PT Cruisers are stylish and popular wedge-shaped cars manufactured by Chrysler and inspired by the panel vans of the 1930’s. Some of the most common problems reported by PT Cruiser owners are PT Cruiser idle problems—rough or bogged down idling—when the PT Cruiser comes to a complete stop or when the air condition is running.

What does code 505 mean on PT Cruiser?

Note that some codes will start with a P. Codes related directly to PT Cruiser Idle problems will be “Error 505, The idle speed air control motor doesn’t seem to be working correctly” or “Error 1294, Can’t get to target engine speed, check for vacuum leaks and idle speed motor issues.”

What causes a PT Cruiser fuel injector to go bad?

If a fuel injector is not operating properly, it will either let too much or too little fuel into the combustion chamber relative to the amount of air. There are many reasons why a fuel injector may go bad, as well as different symptoms relative to how they went bad. For more, check out Chrysler PT Cruiser bad fuel injector symptoms.

What are the oxygen sensors on a PT Cruiser?

The oxygen sensors that are equipped in your Chrysler PT Cruiser are responsible for monitoring the exhaust to help the ECU determine the correct air/fuel mixture. Of all the sensors equipped in your vehicle, the O2 sensors may have it the hardest. They deal with super hot exhaust that can cover them in deposits that can leave them ineffective.

Of all the sensors equipped in your vehicle, the O2 sensors may have it the hardest. They deal with super hot exhaust that can cover them in deposits that can leave them ineffective. The heat of the exhaust can also bake the wiring going to/from them over time. If an oxygen sensor goes bad, it can make your PT Cruiser run too lean (or rich).

These packs are fired by the engines computer at exactly the right time to provide the optimal ignition timing. If a coil pack goes bad, it’ll cause a misfire and rough idle condition. Really, your PT Cruiser will be running rougher at any RPM, but a misfire will be most pronounced at idle.

The oxygen sensors that are equipped in your Chrysler PT Cruiser are responsible for monitoring the exhaust to help the ECU determine the correct air/fuel mixture. Of all the sensors equipped in your vehicle, the O2 sensors may have it the hardest. They deal with super hot exhaust that can cover them in deposits that can leave them ineffective.

If a fuel injector is not operating properly, it will either let too much or too little fuel into the combustion chamber relative to the amount of air. There are many reasons why a fuel injector may go bad, as well as different symptoms relative to how they went bad. For more, check out Chrysler PT Cruiser bad fuel injector symptoms.

Where can I buy a 2006 Chrysler PT Cruiser?

Find your next car by browsing our extensive new and pre-owned 2006 Chrysler PT Cruiser inventory from local Chrysler dealerships and private sellers. You can also compare prices, trim specifications, options, reviews, scores and recall history of 2006 Chrysler PT Cruiser with similar vehicles.

Why does my Chrysler PT Cruiser not start?

Find the most common driver-reported problems that are to blame when a Chrysler PT Cruiser won’t start. If the engine does not crank (or cranks but won’t start), the wireless control module (wcm) may have locked up. this… The battery is considered dead when there isn’t enough charge to start the engine or run electrical components.

When is the worst year for PT Cruiser problems?

In general, 2006 is the worst year for PT Cruiser problems. Here the engine light is constantly on and the engine idles rough. The engine light will repeatedly turn on after solutions to fix the problem are attempted.

Why does my PT Cruiser stall while driving?

This is the most dangerous of the PT Cruiser problems. It involves the engine to completely stall out while driving. It can happen sporadically while driving, giving the driver no warning as to when it will happen next. For some drivers, the issue occurs when a certain RPM is achieved. For others, the problem occurs at a certain speed.

What causes engine light to come on on PT Cruiser?

11 people found this helpful. my 2007 pt did same thing, engine light came on , car was jerking and bucking, ( had nothing to do with the a/c or heat) it was the cam positon sensor, on line the part is 35.99 to 55.99 depending on where you buy it, local garage did mine part and labor for 162.00 29 people found this helpful.

Why does my 2004 PT Cruiser keep stalling?

My Wifes 2004 pt cruiser began bucking and stalling, I took it to the shop ,they plug it into their computer and tell me the AC cooling fan itself was burned out causing the car to overheat and stall. So we replaced it and the car still does the same thing.

Where is the engine code on a PT Cruiser?

When I restarted the engine, the codes were gone and the engine ran like it suppose to. When the cam sensor came I installed it anyway and now the car drives fine. If you turn the key on and off three time in a row, your engine code will be displayed where the odometer is located. No need to go to a shop! 19 people found this helpful.

Author Image
Ruth Doyle