Why does my Insite not recognize my ECM?
Why does my Insite not recognize my ECM?
Insite will not connect/recognize ECM I have version 7.6.0.272 using Nex IQ USB link. ecm. I tried my Nex IQ USB link with another shops laptop and it worked on the same truck. If use the NEX IQ device tester, it recognizes the ecm, but when I use the INSITE it will not recognize it. I have it set to USB Link – Auto detect – RP1210A. Any ideas?
Why is my code reader not turning on?
Long story short, check fuse #13 in the front fuse block. Short story long, the fuse for the cigarette lighter socket (the one on the left) also protects the 12v pin at the OBD2 port. If your phone charger or whatever pops that fuse, your code reader (or scan tool that uses that 12v pin for power) won’t turn on.
Why is my OBD2 scanner not communicating with my car?
Each time I have tried scanning my vehicle for codes using the OBDII scanner, there is a message on the scanner stating that it is unable to communicate with vehicle. There are lots of issues with my car, but I am not able to correct them because of the OBDII issues.
Why does my nexiq Insite not connect to my PC?
(08-23-2014, 06:25 PM)Ken Mech Wrote: I ran into this problem last night during a Teamview session with a Celect Plus, he had the Nexiq adapter & Insite 7.6.0 installed. Originally we were able to connect “once” thru the cab plug, but after one “key-off”, it wouldn’t connect again…even at the ECM direct plug-in
Why does my car not allow code readers?
Just weird because all the other locations like that say not used. The car is just running real sluggish since the check enigine light has come on and now I cannot read the codes. Any more advice would be great. THANKS helpful? That is weird because the fuse panel skips over 51 check out below. helpful? Thanks.
Why does my can / OBDII reader not read?
When I plug my Can/OBDII reader into the port, it fails saying it cannot read. When I plug in my Superchips Cortex programmer in and attempt to do a tune, it tells me it cannot detect ignition. When I plug in a Smarty JR, it just keeps cycling trying to detect and eventually errors.
Is there an app that can read engine code?
There is an initial investment, as the app is shipped with a ​Bluetooth enabled device that plugs into your car’s information data port where it sucks the codes from the vehicles computer and transmits them to your phone. But these apps are reasonable in cost and can provide some great information.
Each time I have tried scanning my vehicle for codes using the OBDII scanner, there is a message on the scanner stating that it is unable to communicate with vehicle. There are lots of issues with my car, but I am not able to correct them because of the OBDII issues.
