Why does my Chrysler Sebring have a red lightning bolt?
Why does my Chrysler Sebring have a red lightning bolt?
Thank John. In Chrysler speak, the red lightning bolt usually means a charging system or electrical malfunction. Your other lights and issues might come from the same cause. If the system voltage gets too low or too high, all sorts of things start to go haywire.
What does it mean when your Sebring won’t start?
If the plugs are firing at the wrong time, or something has happened to cause the camshaft to no longer be in sync with the crankshaft, your Sebring won’t start. There will usually be OBDII codes associated with timing related problems, but not always.
Why is the anti security light not blinking?
Anti security light is on not blinking and car won’t star… replace starter and had battery tested good and now car won’t start’ red anti security light is on but not flashing My car has 173330 miles. My car has an automatic transmission. The anti-theft system is engaged. You will need to have the system scanned to see why the system is active.
Where is the Red security light on my car?
Two weeks ago while using my remote lock, one of my kids pulled one of the sliding doors open just as it was locking. Upon coming back to vehicle about 10 minutes later, all interior lights were illuminated and the small red security light was illuminated on the dashboard (locted on upper right hand side above temperature gauge).
Thank John. In Chrysler speak, the red lightning bolt usually means a charging system or electrical malfunction. Your other lights and issues might come from the same cause. If the system voltage gets too low or too high, all sorts of things start to go haywire.
If the plugs are firing at the wrong time, or something has happened to cause the camshaft to no longer be in sync with the crankshaft, your Sebring won’t start. There will usually be OBDII codes associated with timing related problems, but not always.
Why does my car security light keep coming on?
If the light comes on when you turn on the key without starting and blinks and comes back on or just stays on after 10 or 15 seconds, or does this intermittently, you are probably having this problem with the SKIM module reading the key. If it is a bad connection to the key antenna, this is a very easy and cheap fix.
How to stop a car with a red light?
I cleared up the “red dot” / start and then stall problem VERY EASILY. TIP: you can turn on the key and wait 10 seconds or so until the red dot goes off before starting, if you are having start / stall trouble, you can do this as many times as you like without locking out the ignition and having to wait.