Why does my Chevy truck clunk when I turn?
Why does my Chevy truck clunk when I turn?
Mine in the 2010 is different and there is a huge cv looking boot and u-joints on it that were clunking on me. I replaced and it went away. I would presume you got the “updated” version if you replaced your intermediate shaft so would not suspect it to be bad. It could be that something is shifting in the suspension and making the clunk.
How can I Turn my steering wheel to the left?
Turn the wheel all the way to the left and hold it there tightly. Then loosen the hose line and and turn the wheel all the way to the right to bleed it out with hope that air comes out. Hold the wheel tight to the right while you tighten the hose back down. Have some fluid handy to refill the resivor.
Why does my Silverado make a popping noise when I turn?
The noise seemed to be coming from the passenger side, but I can feel the pop through the floor as well. The noise has become progressively louder (sometimes a BANG!) and appears to be louder the steeper the incline I park on. The noise has started to occur in drive at low speeds, but only during sharp LEFT turns.
Mine in the 2010 is different and there is a huge cv looking boot and u-joints on it that were clunking on me. I replaced and it went away. I would presume you got the “updated” version if you replaced your intermediate shaft so would not suspect it to be bad. It could be that something is shifting in the suspension and making the clunk.
Why does my truck stall when I make a left turn?
Messages: 97. If it’s stalling due to the additional load applied by power steering at idle (foot off accelerator) then the engines idle control system could be at fault. Also with the heater changing this could be a vacuum problem.
Turn the wheel all the way to the left and hold it there tightly. Then loosen the hose line and and turn the wheel all the way to the right to bleed it out with hope that air comes out. Hold the wheel tight to the right while you tighten the hose back down. Have some fluid handy to refill the resivor.
Where is the turn signal on a GM Truck?
It is located on the frame crossmember above the spare tire. It was corroded and the clip was weak. I cleaned it up, put some electronics grease on it and put it back together. Then I used zip ties to hold the connector together. I never had an issue after that.