Why does my 73 Corvette have a squeak?
Why does my 73 Corvette have a squeak?
Remember, this all started with a slight squeak. The squeak was a dry half shaft u-joint. A Corvette has 4 of them and they should be checked and greased regularly. We had a slight squeak in the right rear of our 73 Corvette and discovered it was a bad u-joint.
Why does my 1978 Corvette Indy Pace Car track poorly?
My 1978 Corvette indy pace car seems to track poorly. The rear axle appears to be in poor allignment. In what ways is the rear axle adjustable? She always started right up until it got wet. Turns over strong sprayed ether in carburetor she wants to rip but it’s just shy of catching did have …
Why does my 1980 Corvette not turn over?
She always started right up until it got wet. Turns over strong sprayed ether in carburetor she wants to rip but it’s just shy of catching did have … 1980 corvette battery tests that it is good, but the car will not start or turn over. new gauges for 1975 vette don’t seem to work properly. Bought new gauges for my 1975 vette from Ecklers.
Why is the steering coupler on my 1969 Corvette not working?
This oil soaked, well-worn steering coupler off of a 1969 Corvette created excess play. The best way to check this coupler is to have someone turn the steering wheel within the free play range. Watch for movement in the coupler that does not transmit to the lower flange.
Why does my Corvette have a vibration in it?
Figuring out what’s causing that vibration is the real challenge. It’s a good idea to start with the basic, tire-related culprits such as tire wear, pressure and balance. That said, there are a few issues unique to the Corvette that require special care and attention.
What kind of car was the 1979 corvette?
1979 Red Corvette 4spd Hot Rod For more information, pictures, and vid 1979 Chevy Corvette L-82 – 350 cu in V8 – Automatic – New Custom Interior [Red & Dark Gray Le
What should the alignment be on a 1963 Corvette?
1963-1982 Corvette Performance Alignment Specifications. Caster: positive 3-1/4 degrees (plus or minus ¼ degree) (there should be no more than a ½ degree variation side to side). To offset for crowned roads set the left caster to 2-3/4 degrees positive and the right 3-1/4 degrees positive.
Why does my Corvette make a squeak when I drive?
As time goes on you don’t “get to it” and the squeak is now noticeably louder and more frequent. You may also notice a slight vibration when you are driving in a straight line. You still ignore the noise only now it is starting to sound like something is loose.
