Most popular

Why does my 1980 Corvette not turn over?

Table of Contents

Why does my 1980 Corvette not turn over?

She always started right up until it got wet. Turns over strong sprayed ether in carburetor she wants to rip but it’s just shy of catching did have … 1980 corvette battery tests that it is good, but the car will not start or turn over. new gauges for 1975 vette don’t seem to work properly. Bought new gauges for my 1975 vette from Ecklers.

What to do when your Corvette C5 wont start?

Pull the correct fuses (found in the owners manual) and reset the codes. If that doesn’t work you can try this little trick: set the heat on high, shut the car off, discount the battery on the negative side, wait five minutes, reconnect and see if your problem has gone away.

How to ask a question about a C3 Corvette?

On C3 Ask Corvette Garage you can submit a question about problems you have with a C3 Corvette. One of our writers or a fellow Corvette enthusiast will reply ASAP. Also you can Respond to other peoples questions.

Why is my climate control not working on my Corvette?

It’s common for vacuum hoses to crack, split, fall off their connections, or even during the process of repairing something else, a hose gets taken off but never gets put back on. Without proper vacuum, you won’t get the pressure you need to run your climate control properly.

She always started right up until it got wet. Turns over strong sprayed ether in carburetor she wants to rip but it’s just shy of catching did have … 1980 corvette battery tests that it is good, but the car will not start or turn over. new gauges for 1975 vette don’t seem to work properly. Bought new gauges for my 1975 vette from Ecklers.

Are there any classic corvettes that do not work?

Classic corvettes are no different in this instance. So as to help newcomers to the classic car world to avoid being caught off-guard, we’ve compiled a list of things that commonly do not work on C3 corvettes, gathered from our own experience buying, selling, and working on these cars for the past decades.

On C3 Ask Corvette Garage you can submit a question about problems you have with a C3 Corvette. One of our writers or a fellow Corvette enthusiast will reply ASAP. Also you can Respond to other peoples questions.

Why are the horns on my Corvette not working?

Aside from the corrosion of the bar metal contacts, the horns themselves would often go bad due to moisture and debris, thanks to their position right behind the headlights. Air Conditioning – Long story short, it very rarely works.

What was the interior of a C3 Corvette?

The C3’s interior had numerous optional upgrades: tinted glass, air conditioning, power windows, power steering, tilt-telescope steering column, AM/FM radio or stereo, headrests, leather seating, rear window defogger, and a factory installed alarm system.

What causes a corvette steering wheel to turn?

Be sure to look at the power steering pressure and return hoses for binding concerns as well. Upon initial start-up, do not place your arm between the steering wheel spokes. A maladjusted control valve can cause the steering wheel to turn abruptly left or right on its own.

When did the C3 Corvette go out of production?

The C3 Corvette was amidst its death throes during the 1982 model year. In its 15th year of production, it had few fans left and open derision was the norm among enthusiasts. The C3 had overstayed its welcome by at least five years.

What’s the name of the third generation Corvette?

Chevrolet Corvette (C3) The C3 is the third generation of the Chevrolet Corvette, and marks the second time the Corvette would carry the Stingray name, though only for the 1969 – 1976 model years. This time it was a single word as opposed to Sting Ray as used for the 1963 – 1967 C2 generation.

What’s the problem with the window on a corvette?

Removed window for painting.Having problem re attaching with hinges, window not alighning with hinges properly no shims yet must be easier way.how do you … Where is the defroster cable? I can hear a slight noise with the clutch out and car in netural when I press clutch in slighty the noise goes away. adjustment needed?

How is the center console taken apart on a 1980 Corvette?

It has been about a month and a half, but went out to start my car , and it was dead, so I replaced the battery, and car turns over like a champ but will … The air flow only comes out of the floor vents. How is the center console taken apart in order to get to the heat and a/c controls on 1980 vette in order …

Where does the air come from on a 1980 Vette?

The air flow only comes out of the floor vents. How is the center console taken apart in order to get to the heat and a/c controls on 1980 vette in order … Engine starts fire and idles great when it is put in gear the engine rpms drop significantly.

What kind of brake light does a 1976 Corvette have?

I have a 1976 Corvette. The drivers side brake light turns on when pressing the brake pedal, but when it lights up it’s really dim. And just a few minutes … replaced all calipers and master cyl,& brake pads.

Why is the seat belt buzzer on my Corvette not working?

The seat belt buzzer for my corvette won’t shut off and I cannot find the relay to remove it to shut it up. Can anyone direct me to the place where … Click here to write your own. I have a 1977 corvette. To put the back main gasket in, can you pull the oil pan and put it in from there?

It has been about a month and a half, but went out to start my car , and it was dead, so I replaced the battery, and car turns over like a champ but will … The air flow only comes out of the floor vents. How is the center console taken apart in order to get to the heat and a/c controls on 1980 vette in order …

Removed window for painting.Having problem re attaching with hinges, window not alighning with hinges properly no shims yet must be easier way.how do you … Where is the defroster cable? I can hear a slight noise with the clutch out and car in netural when I press clutch in slighty the noise goes away. adjustment needed?

Pull the correct fuses (found in the owners manual) and reset the codes. If that doesn’t work you can try this little trick: set the heat on high, shut the car off, discount the battery on the negative side, wait five minutes, reconnect and see if your problem has gone away.

Why does my 2002 corvette stay in neutral?

Just bought a 2002 coupe and noticed that the passenger tempeture control knob doesn’t change the temperature display when you turn the knob up or down. … Pulled corvette into garage-activated trunk release-corvette stays in neutral when i try to shift-will not work in drive or reverse-closed trunk;still …

It’s common for vacuum hoses to crack, split, fall off their connections, or even during the process of repairing something else, a hose gets taken off but never gets put back on. Without proper vacuum, you won’t get the pressure you need to run your climate control properly.

What should I do if my Corvette battery goes dead?

Have 2002 convertible 26000 miles after driving 1/2 hour fuel gauge goes to empty, check gauges light and low tire pressure . Unhook battery then connect … Have a ‘99 C5 that the battery went dead in, after recharging battery the instrument cluster keep going thru intermittent cycles saying Service ABS, Service …

The seat belt buzzer for my corvette won’t shut off and I cannot find the relay to remove it to shut it up. Can anyone direct me to the place where … Click here to write your own. I have a 1977 corvette. To put the back main gasket in, can you pull the oil pan and put it in from there?

Where is the tune up button on a corvette?

Turn ignition on, car stereo off. Display on car stereo should show time. Push the set button on the face of the stereo. Green light at button will illuminate. Use the tune DOWN button for HOURS, tune UP button for MINUTES. The CDM box and power antenna relay are located behind the passenger seat, below the insert in the pocket.

What is the sender resistance on a corvette?

The sender is a variable resistance that controls the current flow through the gauge. For the C1 cars the sender resistance is 0-32 ohms and for the C3 cars the sender is 0-90 ohms. These senders are at maximum resistance when the tank is full.

Where is the antenna located on a corvette?

You access the antenna from under the left rear quarter panel, above the muffler. If it’s a factory power antenna, there’s a relay inside your console, behind the shifter where power leads from the radio go, and wires to the antenna motor lead from.

Where is the power relay on a corvette?

If it’s a factory power antenna, there’s a relay inside your console, behind the shifter where power leads from the radio go, and wires to the antenna motor lead from. That would, at least for now, be a good place to unhook the power.

Where is the CDM box on a corvette?

The CDM box and power antenna relay are located behind the passenger seat, below the insert in the pocket. If you are experiencing intermittent stereo and/or antenna problems, start here first! The drain at the bottom of this pocket may become clogged causing the pocket to fill with water.

Turn ignition on, car stereo off. Display on car stereo should show time. Push the set button on the face of the stereo. Green light at button will illuminate. Use the tune DOWN button for HOURS, tune UP button for MINUTES. The CDM box and power antenna relay are located behind the passenger seat, below the insert in the pocket.

What to do when your turn signal is not working?

Step 2 – Locate the power distribution center (PDC) or fuse panel to check all system fuses. Learn more – To locate the fuse consult the owner’s manual or search Google Images. Step 3 – When a turn signal flasher or relay fails the blinkers will not operate or come “ON”, but not blink.

What causes turn signals to go bad on a car?

Signalling Problems. Turn signals on either side of the vehicle can be wired in series, much like the bulbs on a strand of Christmas tree lights. If one goes bad, or it isn’t properly grounded, it can affect the corresponding light on the same side. Check for damaged or burned-out bulbs in all turn signals on that side.

The air flow only comes out of the floor vents. How is the center console taken apart in order to get to the heat and a/c controls on 1980 vette in order … Engine starts fire and idles great when it is put in gear the engine rpms drop significantly.

What happens when you blow a spark plug on a corvette?

The explosion the spark plugs create moves the cylinder down, and the force produced is transferred to your Corvette’s wheels for motion. If spark plugs are blown, worn out or loose, your Corvette will misfire.

Are there any problems with the first Corvette?

The first Corvette experience nagging problems: doors that wouldn’t stay shut, water leaks, and shoddy workmanship of the otherwise innovative fiberglass body. These issues negatively impacted customer impressions caused sales to plummet.

Why does my Corvette have a lean misfire?

Fuel injectors. If Your Corvette’s battery is faulty or has low voltage, the engine will suffer from a lean misfire. A low voltage battery affects fuel delivery since the fuel pump runs slower than expected. As a result, the fuel pressure is low and a lean fuel condition occurs.

Just bought a 2002 coupe and noticed that the passenger tempeture control knob doesn’t change the temperature display when you turn the knob up or down. … Pulled corvette into garage-activated trunk release-corvette stays in neutral when i try to shift-will not work in drive or reverse-closed trunk;still …

Where is the Horn relay switch on a 1994 Corvette?

I’d like to know were the horn relay switch is on my 1994 Corvette. When you start out cold in open loop, everything is perfect, once its in cosed loop its ok for a few minutes then will start to run ruff and then kick … switches! what is the function of the switch on the right of the headlight switch.

I have a 1976 Corvette. The drivers side brake light turns on when pressing the brake pedal, but when it lights up it’s really dim. And just a few minutes … replaced all calipers and master cyl,& brake pads.

Why are the lights on my Corvette not working?

If pulling the plug on the switch doesn’t help, try the delay relay. Got the lights fixed. It turned out to be the map light switch in the right door panel, had a wire shorted and the switch was broken. Orderes new switches (both sides) and lights are fine.

What to do if your interior lights go off?

Click to expand… Would sure be worth the time to pull the plug and see if the lights go off. They turn on when ground is supplied, either through the light switch or the delay relay. If pulling the plug on the switch doesn’t help, try the delay relay.

Why does my 1978 Corvette Indy Pace Car track poorly?

My 1978 Corvette indy pace car seems to track poorly. The rear axle appears to be in poor allignment. In what ways is the rear axle adjustable? She always started right up until it got wet. Turns over strong sprayed ether in carburetor she wants to rip but it’s just shy of catching did have …

What happens when there is oil in the intake manifold?

Here comes the intake or inlet manifold. It is a series of tubes that evenly distribute the air into the cylinders. It is bad news when there is oil in intake manifold. Why does this happen and what problem it can lead to? The inlet manifold passes the air to the cylinders through some valves.

Where does the oil go when the PCV valve is blocked?

When oil cannot pass freely through the passage, it gathers inside the top of the cylinder head. When the passage is totally blocked, the oil will go through the PCV valve and enter the air intake manifold. What you have to do to get rid of this problem is to pour an engine flush formula into the oil and run the engine for a few times.

When to worry about oil in air intake?

It is the first component to look into when the problem occurs although you should not be worried if there is a small amount of oil in air intake. It is not rare to have blocked PCV valves on cars with less than 100,000 mileage. You have to examine the entire PCV system.

What can cause 1989 Harley pukes oil out crankcase vent?

Re: 1989 harley pukes oil out crankcase vent when started… Blow by compression. Severe engine problems. Pull the heads look at cylinder walls You can’t post conmments that contain an email address. I have 1983 Harley Sportster 1000 that won’t fire when I first turn the key, but after a few minutes it fires right up what can cause this?

What does it mean when your crankcase breather is blowing oil?

If your crankcase breather is passing oil, chances are that something’s wrong (Okay, we know something’s wrong, but don’t be too alarmed). Here are some things to look for while you’re searching for the source of the issue:

What happens when a blow by goes through a crankcase?

This is the area where most catch cans fall short. When blow-by exits the crankcase, it’s hot, really, really hot. So hot, in fact, that the oil and fuel held within it are in a gaseous state and can flow like the wind through pipes, and around cylinders, without ever becoming liquid again.

Why is my Blend door not working on my Corvette?

Check for proper installation or take your Corvette to whoever installed the head unit, if all is connected properly then the head unit was bad to begin with. If you are having inconsistent airflow issues, you could be experiencing out of sync blend door problems. This is a pretty simple fix.

Author Image
Ruth Doyle