Why are the turn signals on my Chevy truck not working?
Why are the turn signals on my Chevy truck not working?
Also the right rear tail lights don’t work. Can’t find a blown fuse and the bulbs appear to be good. It also doesn’t happen all the time….weird. I’d start by adding a 6 ohm 50 watt resistor per each turn signal location to see if that corrects the problem. Just picked up this truck last week…
Why does my turn signal light not blink?
I have a problem like this on my 2008 Chevy Suburban. Left rear turn signal light does not blink when using the turn signal. The light doesn’t blink when I turn on the hazard flasher. The bulb is good. The fuses are good. I took it to the dealer. They tried replacing the Body Control Module (BCM) but that didn’t fix it.
Is it possible to change the turn signal relay?
Is it possible to change it to a type that is not load dependent – so one could install LED turn signal light / brake lights without changing the flashing interval of the turn signal lights?
What’s the issue with the blinker on my Chevy Silverado?
When I figure it out ill post. 2012 2500 chevy lml. Same issue basically. 2013 Silverado, someone put led lights in the rear. Blinker was fine for over a year and now I’m getting the normal blink for 5 seconds than goes hyper. No lights out, same issue on left and right blinker.
Also the right rear tail lights don’t work. Can’t find a blown fuse and the bulbs appear to be good. It also doesn’t happen all the time….weird. I’d start by adding a 6 ohm 50 watt resistor per each turn signal location to see if that corrects the problem. Just picked up this truck last week…
Can a bad ignition switch cause a Chevy Silverado to stall?
Your Silverado stalls because the faulty switch turns off the fuel pump or power to the ignition. When this happens, the engine will not be able to run until it gets that signal back. 2. Starts then Dies If your Chevy Silverado is starting right up, but then immediately dies, that is a very good indication that the ignition switch is bad.
When I figure it out ill post. 2012 2500 chevy lml. Same issue basically. 2013 Silverado, someone put led lights in the rear. Blinker was fine for over a year and now I’m getting the normal blink for 5 seconds than goes hyper. No lights out, same issue on left and right blinker.
Why do turn signals Blink normal then rapid?
Exact same problem couple normal flahes then hyper flash and once in a while left will act normal, im also having problems with right rear, tail light, brake function and flasher blowing Ive been told possible bad bulb, ground, multi switch on column, flasher relay, or control module.it annoys more then anything.
