Where is the switch commutateur interruptor on a car?

A switch commutateur interruptor is what allows the turn signal to blink while the brake pedal is being pressed down. Without it you need a separate bulb for the turn signals to work properly. It’s located behind the steering wheel on most pre air bag cars. Not sure on an airbag car, but it should be simple to do.

What’s the pressure switch on a Chevy truck?

The Chevrolet truck uses two air conditioning pressure switches: a high- and low-pressure switch. The high-pressure switch is designed to shut down the compressor if the line pressure gets dangerously high.

Where is the high side switch on a Chevy?

Locate the high- and the low-side switches. The high-side switch is located on the smaller of the two air conditioning lines close to the radiator on the passenger side of the vehicle.

How do you remove ignition switch from Corvette?

Insert your ignition key into the ignition coil and leave it in the “Off” position. Insert a straightened out paper clip into the slot just next to the key slot. Make sure to press the paper clip in all the way. Turn the key to the “Acc” position and pull on both the key and the clip at the same time to slide the ignition coil out.

Where is the clutch cycling switch on an evaporator?

The clutch cycling switch is a type of device called a transducer, which changes internal resistance in response to changes in pressure. The clutch cycling switch measures the low side A/C pressure near the evaporator outlet and is often mounted on the accumulator. Part 1 of 3: Locate the A/C clutch cycling switch

Where is the cycling switch on a compressor?

Step 1: Locate the compressor clutch cycling switch. The cycling switch will typically be mounted to the accumulator. The accumulator is usually found at the back of the engine compartment, mounted to the firewall. Tip: You can often get free repair manuals. Step 2: Disconnect the negative battery cable.